METHODS: Three sets of fake archwires (AWs) and brackets (Bs) as well as a set of controls were immersed in AS and placed in an incubator shaker at 50 rpm and 37°C. At Days 0, 1, 7, 14, 21, and 28, the pH of the AS medium was measured and 3.0 ml of AS was collected and stored at -20°C for elemental analysis.

RESULTS: Significant changes in pH were observed on Days 0, 1, 7, 14, 21, and 28 in the AS of the AW group. However, these changes were only observed in the B group on Days 0 and 7. The fake samples released a large quantity of sodium (Na), potassium (K), and calcium (Ca) ions, at concentrations exceeding 100 mg/L, post-28 days of immersion. The control and fake braces samples released other ions; such as lithium (Li), magnesium (Mg), barium (Ba), chromium (Cr), copper (Cu), lead (Pb), and aluminium (Al); at concentrations that did not exceed 10 mg/L.

MATERIAL AND METHOD: Two hundred discs of PEEK were prepared of 6 mm × 2 mm × 10 mm dimension. The discs were randomly divided into five groups (n = 40) for treatment, Group I: treatment with deionized distilled water (control group); Group II: PD therapy using curcumin PS; Group III: discs treated and abraded with air-borne particles (ABP) silica (30 μm particle size) modified alumina (Al); Group IV: ABP of alumina (110 μm particle size); and Group V: The PEEK were finished with 600-μm grit size straight diamond cutting bur installed in high speed hand-piece. The surface profilometer was used to evaluate the values of surface roughness (SRa) of pretreated PEEK discs. The discs were luted and bonded to discs of composite resin. The bonded PEEK samples were placed in Universal testing machine to evaluate shear BS. The type of BS failure for PEEK discs pre-treated with five regimes respectively was evaluated under stereo-microscope. The data was statistically analyzed using one-way ANOVA and the comparisons between mean values of shear BS were evaluated by Tukey's test (ρ≤0.05).

RESULTS: The PEEK samples pre-treated with diamond cutting straight fissure burs displayed statistically significant highest value of SRa values (3.258± 0.785 µm). Similarly, the shear BS was observed to be higher for the PEEK discs pre-treated with straight fissure bur (22.37±0.78 MPa). A comparable difference but not statistically significant difference was observed between PEEK discs pre-treated by curcumin PS and ABP-silica modified alumina (ρ ≥ 0.05).

METHODS: Recently extracted lower first premolars were randomly categorized into three experimental groups (n = 15 samples), positive control (n = 5 samples), and negative control group (n = 5 sample). Samples from the experimental groups and positive control group were subject to cavity Class I occlusal preparation followed by modified coronal pulpotomy. Different types of bioceramic dressing material were placed in 3 mm thickness accordingly, group 1 (Biodentine), group 2 (MTA Angelus), and group 3 (ProRoot MTA). No dressing material was placed in the positive control group (group 4). All samples were placed in the incubator for 24 h at 37℃, 100% humidity, for the materials to be completely set. The final restoration was placed using the Z350 resin composite. A double layer of nail varnish was applied over all the sample surfaces except the occlusal site. Whereas the samples' surfaces in the negative control, were completely covered. A 3 mm length was measured from the root apex of the samples from each group, before proceeding with the resection. The bacterial leakage test was performed using Enterococcus faecalis TCC 23,125, and a sample from each experimental group was randomly chosen for SEM. Data analysis was conducted under the One-way ANOVA test, completed by Tukey's post hoc test.

METHOD: This was an unmatched case-control study in which children with ASD were recruited from an autism early intervention center and typically developed (TD) children were recruited from government-run nurseries and preschools. Urine samples were collected at home, assembled temporarily at study locations, and transported to the laboratory within 24 h. The Al concentration in the children's urine samples was determined using inductively coupled plasma mass spectrometry (ICP-MS).

METHODOLOGY: This study was designed as a parallel, double blind, randomized controlled trial where symptomatic mature permanent teeth with carious pulp exposure meeting the inclusion criteria were randomly treated with full pulpotomy using one of 3 calcium silicate-based materials (ProRoot MTA, Biodentine and TotalFill). Full pulpotomy was performed, and haemostasis was achieved via a cotton pellet moistened with 2.5% NaOCl. A 3-mm layer of the calcium silicate-based material was randomly placed as the pulpotomy agent through a block randomization process followed by a resin-based composite restoration. Postoperative periapical radiograph was taken. Clinical and radiographic evaluation were completed after 6 months and 1 year. The patient and evaluator were blinded to the type of materials used. Pain levels were scored preoperatively and 7 days after treatment. Effect of potential prognosis factors including gender, age, diagnosis, bleeding time and type of caries were also analysed.

RESULTS: One hundred and sixty-four teeth in 146 patients received full pulpotomy and were randomly assigned to either the tested or control material through block randomization technique (50 MTA, 50 Biodentine and 64 TotalFill). The age ranged from 10 to 70 years. The diagnosis was irreversible pulpitis in 112 teeth (72%) and reversible pulpitis in 28 teeth (28%). The majority of patients presented with severe pain, during the first week 96.9% reported complete relief of pain or mild pain. Four cases had immediate failure. At 6 months the overall success rate was 92.2%, over 1 year 156/164 teeth attended follow-up with 12 failures (2 restorative failures and 10 endodontic failures), the overall success of pulpotomy at 1 year was 92.3% (144/156); 91.8% in MTA, 93.3% in Biodentine and 91.9% in TotalFill with no significant difference amongst the groups and no side effects observed. No significant association was evident between outcome and the investigated variables.

EXPERIMENT: Geological formations contain organic acids in minute concentrations, with the alkyl chain length ranging from C4 to C26. To fully understand the wetting characteristics of H2 in a natural geological picture, we aged mica mineral surfaces as a representative of the caprock in varying concentrations of organic molecules (with varying numbers of carbon atoms, lignoceric acid C24, lauric acid C12, and hexanoic acid C6) for 7 days. To comprehend the wettability of the mica/H2/brine system, we employed a contact-angle procedure similar to that in natural geo-storage environments (25, 15, and 0.1 MPa and 323 K).

METHODS: Ninety-six cavities were prepared in the maxillary first molars of 56 male Wistar rats. The dental pulps were intentionally exposed and randomly divided into four groups according to the application of pulp capping materials: MTAPPL; phosphorylated pullulan (PPL); a conventional MTA (Nex-Cem MTA, NCMTA; positive control); and Super-Bond (SB; negative control). All cavities were restored with SB and observed for pulpal responses at 1-, 3-, 7- and 28-day intervals using a histological scoring system. Statistical analysis was performed using Kruskal-Wallis and Mann-Whitney U-test with Bonferroni's correction, and the level of significance was set at 0.05. DMP1 and CD34 antigen were used to evaluate odontoblast differentiation and pulpal vascularization, respectively.