RESULTS: The longer time and higher power of ultrasonics accelerated the glycosylation reaction with an increase in glycosylation degree and browning index values. Compared with original FG, FG-κC mixture and bovine gelatin, UAG-modified FG possessed higher emulsification activity index, emulsion stability index, gel strength, hardness and melting temperature values. Among them, gelatin modified by appropriate ultrasonic conditions (200 W, 0.5 h) had the highest emulsifying and gelling properties. Rheological results showed that UAG contributed to the gelation process of gelatin with advanced gelation time and endowed it with high viscosity. Structural analysis indicated that UAG promoted κC to link with FG by the formation of covalent and hydrogen bonds, restricting more bound and immobilized water in the gels, exhibiting higher gelling properties.
CONCLUSION: This work showed that UAG with κC is a promising method to produce high gelling and emulsifying properties of FG that could replace MG. © 2023 Society of Chemical Industry.
METHOD: The dispensing system is based on an Arduino circuit breadboard where an ATmega328p microcontroller was pre-installed. To sense the proximity, a light-dependent resistor (LDR) is used where the laser light is to be blocked after the placement of human hands, hence produced a sharp decrease in the LDR sensor value. Once the LDR sensor value exceeds the lower threshold, the pump is actuated by the microcontroller, and the sanitizer dispenses through the nozzle.
RESULTS AND DISCUSSION: A novel design and subsequent fabrication of a low-cost, touchless, automated sanitizer dispenser to be used in public places, was demonstrated. The overall performance of the manufactured device was analyzed based on the cost and power consumption, and environmental factors by deploying it in busy public places as well as in indoor environment in major cities in Bangladesh, and found to be more efficient and cost-effective compared to other dispensers available in the market. A comprehensive discussion on this unique design compared to the conventional ultrasonic and infra-red based dispensers, is presented to show its suitability over the commercial ones. The guidelines of the World Health Organization are followed for the preparation of sanitizer liquid. A clear demonstration of the circuitry connections is presented herein, which facilitates the interested individual to manufacture a cost-effective dispenser device in a relatively short time and use it accordingly. Conclusion: This study reveals that the LDR-based automated hand sanitizer dispenser system is a novel concept, and it is cost-effective compared to the conventional ones. The presented device is expected to play a key role in contactless hand disinfection in public places, and reduce the spread of infectious diseases in society.
Material and method: Sixty freshly extracted human single-rooted mandibular premolar teeth were selected for the study. Teeth with fractured root, cracks, anddilacerations were rejected. All teeth were cleaned with ultrasonic scalers. Standard access opening was done and root canal treatment was performed with rotary files followed by obturation. After storing in saline for a week apical 3 mm of the root was resected at 900 angles to the long axis of the root. Retro cavity preparation was done with ultrasonic tips. The teeth were divided into four groups of 15 specimens each. Group I - Biodentin, GroupII-Bioaggregate, Group III - MTA Plus, and Group IV - MTA. After the restoration of retro cavities of all the teeth as per manufacture instructions, two coats of nail varnish were applied to leave apical 3 mm. All teeth were stored in 2% methylene blue for 72 h followed by emersion in 65% nitric acid for the next 72 h for Dye extraction. The obtained supernatant solution was then centrifuged and optical density or absorbance was measured with a UV spectrophotometer.
Result: Microleakage was found to be increasing in this order: Biodentin 0.01).
Conclusion: All materials exhibit some amount of microleakage. Biodentin shows the least microleakage among all the bioceramic material groups. Hence, Biodentin and bioaggregate are better material of choice for the retrograde filling to prevent microleakage.