Displaying all 11 publications

Abstract:
Sort:
  1. Zalina Laili, Mohd Zaidi Ibrahim, Muhamat Omar
    MyJurnal
    A study has been carried out using a gamma-ray spectrometric system to determine the natural
    radioactivity level in bricks made from industrial waste and their associated radiation hazard.
    Brick-1 and brick-2 contained waste from coal power plant and granite industry, respectively. The
    leachability of radionuclides from these bricks was also investigated. The activity concentration
    values of 226Ra,
    228Ra,
    232Th, and 40K are 64.25, 63.15, 67.9 and 254.19 Bq/kg, respectively in brick-
    1, and 193, 164.48, 164.63 and 1348.75 Bq/kg, respectively in brick-2. The radiation hazard
    indexes such as radium equivalent activities (Raeq), representative level index (Iγr), external hazard
    index (Hex) and internal hazard index (Hin) were calculated and compared with the internationally
    approved values. Results indicate that brick-1 showed less radiological hazard than brick-2. This
    suggested that brick-1 could be used in building construction without exceeding the proposed
    criterion level.The leachability of 226Ra for bricks showed the activity concentration slightly
    exceeded 1 Bq/L which is the limit generally used for industrial wastewater.
  2. Muhamat Omar, Zalina Laili, Mohd Suhaimi Hamzah
    MyJurnal
    Qualitative and quantitative analysis of samples require good judgment from the analysts. These two aspects in gamma spectrometric analysis of Proficiency Test and solid radioactive waste samples for the determination of radionuclides are discussed. It is vital to judge and decide what energy peaks belong to which radionuclides prior to the creation of customized radionuclide library for the analysis of specific samples. Corrections due to radionuclide decay and growth, and the half-life assigned to a particular radionuclide in the uranium and thorium series are also discussed. Discussion on judgment to confirm the presence of thorium in food samples based on gamma spectrometry and neutron activation analysis is also provided.
  3. Nur Azna Mahmud, Zalina Laili, Ramlah Tajuddin
    MyJurnal
    This study focused, on the activity concentration and radiation hazard assessment of radionuclide in
    bricks. The activity concentrations per unit of mass in the studied bricks ranged from 59.82 to 236.65
    Bqkg'1 for Ra-226, from 66.29 to 185-4 Bqkg'1 for Th-232, and from 283.50 to 1599.67 Bqkg'1for K-fO.
    In terms of radiation hazard assessment, granite bricks exceeded the allowance limit stated by Nuclear
    Energy Agency -Organisation for Economic Co-operation & Development (NEA-OECD) in radiumequilibrium
    activity (Req), External Hazard Index (Hex), Internal Hazard Index (Hin) and
    Representative Level Index (Iw). Thus, this has proof that the naturally occurring radionuclide
    materials present in the brick have a potential in effecting the dwellers health.
  4. Rohyiza Ba’an, Zalina Laili, Mohd Abdul Wahab Yusof, Muhamat Omar
    MyJurnal
    Feasibility studies on the vitrification of spent ion exchange resins combined with glass cullet powder have been conducted using a High Temperature Test Furnace. Bottle glass cullet powder was used as matrix material to convert the ash of the spent resins into a glass. Vitrificat ion of spent ion exchange resins presents a reasonable disposal alternative, because of its inherent organic destruction capabilities, the volume reduction levels obtainable, and the durable product that it yields. In this study, the spent ion exchange resin from the PUSPATI TRIGA reactor of Nuclear Malaysia was combusted in a lab scale combustor and the resulting ash was vitrified together with glass cullet powder in a high temperature furnace to produce a stable spent resin ash embedded in glass. The factors affecting this immobilized waste, such as thermal stability, radiological stability and leachability have all been investigated. However, the outcome of these tests, which include the radionuclide activity concentration in the slag, the optimum conditioning temperature - in relation with volume reduction during vitrification - and the volume mixing ratio of matrix material were reported. It was found that the radionuclides present in spent resins were 54 Mn, 60 Co and 152Eu. The elementary chemical composition (carbon, hydrogen, nitrogen and sulphur) of spent resins was 27.6% C, 5.68% H, 2.04% N and 4.20% S, respectively. The maximum calorific value of spent resins was 1735 kJ/kg. The average activity concentrations of 54 Mn and 60Co in ash at 200oC were 9,411 ± 243 Bq/Kg and 12,637± 201 Bq/Kg. flue gases containing CO2, CO, SO2 and NO started to be emitted above 200oC. The optimum conditioning temperature was also the highest tested, i.e. 900oC in 45 minutes, and the best mixing ratio ash to matrix material was also the highest, ie 1:9. Finally, the leaching analysis of slag at 900oC in 45 minutes showed that the leaching activity of 60Co was below 0.5 Bq/mL.
  5. Zalina Laili, Muhamad Samudi Yasir, Mohd Abdul Wahab Yusof
    Sains Malaysiana, 2017;46:1617-1623.
    The influence of water-to-cement ratio (w/c) on the compressive strength of cement-biochar-spent resins matrix was
    investigated. Spent resins waste from nuclear reactor operation was solidified using cement with w/c ranging from 0.35
    to 0.90 by weight. In this study, biochar was used as a cement admixture. Some properties of spent resins and biochar
    were determined prior to the formulation study. Compressive strength of harden cement-biochar-spent resins matrix
    was determined at 28 days. The compressive strength of cement-biochar-spent resins matrix was found to depend on the
    w/c and the amount of spent resins added to the formulation. The immersion test of cement-biochar-spent resins matrix
    showed no significant effects of cracking and swelling. The compressive strength of the cement-biochar-spent resins
    matrix increased after two weeks in water immersion test.
  6. Phillip, Esther, Muhamad SamudiYasir, Muhamat Omar, Mohd Zaidi Ibrahim, Zalina Laili
    MyJurnal
    Effect of washing solutions’ pH on removal of radium-226 from radium-contaminated soil using distilled water and humic acid extracted from Malaysian peat soil was studied by a single batch washing method. The study encompassed the extraction of humic acid and the washing of radium-contaminated soil using distilled water and humic acid solutions of varying pH in the range between 3 to 11. Activity of radium-226 was determined by gamma spectrometer. In the pH range studied, the removal of radium-226 was greater when humic acid solutions were used compared to distilled water. Greater removal of radium-226 was obtained using highly basic pH washing solutions compared to neutral and acidic solutions.
  7. Esther Phillip, Muhamat Omar, Muhamad Samudi Yasir, Mohd Zaidi Ibrahim, Zalina Laili
    MyJurnal
    Effect of AP+, Ca", Cu" and Fe" on the removal of radium-226 from radium-contaminated soil using humic acid extracted from a Malaysian peat soil was investigated using batch washing method. The concentration of Al,+ Ca", Cu" and Fe" ranged from 0 to 100 ppm. The radioactivity concentration of radium-226 was determined by gamma spectrometer. The removal of radium-226 was enhanced in the presence of AP' with concentration between 20 - 60 ppm. Meanwhile, higher concentration of 80 - 100 ppm did not lead to further increase in the removal of radium-226. The removal of radium-226 was decreased in the presence of Ca" and Cu". In the presence of Fe" with concentration between 20 - 60 ppm, decrease in the removal of radium-226 was also observed. Nevertheless, at concentration between 80 - 100 ppm, the presence of Fe" led to increase in the removal of radium-226.
  8. Zalina Laili, Muhamad Samudi Yasir, Muhamat Omar, Mohd Zaidi Ibrahim, Philip E
    Sains Malaysiana, 2010;39:333-336.
    This study examines the influence of humic acids (HA) on adsorption of radium (Ra) ions onto coir pith (CP) in aqueous solution. The adsorption behaviours of Ra ions onto CP under the influence of HA in aqueous solution were investigated in the series of batch mode adsorption experiments. The effects of various experimental conditions such as pH, contact time, adsorbent dosage and initial concentration of Ra ions have been studied. The results revealed that the presence of HA in aqueous solution enhanced the adsorption of Ra ions onto CP. The adsorption results showed that the percentage of Ra adsorbed was increased with an increase in the pH or alkalinity of aqueous solutions. Time dependence of the batch studies showed that a contact time of one day was sufficient to reach equilibrium. The result also showed that there was no significant difference on the effect of adsorbent dose on adsorption of radium onto CP. It was shown that the equilibrium data could be fitted by Freundlich equation.
  9. Muhamat Omar, Zalina Laili, Julia Abdul Karim, Zarina Masood, Nik Marzukee Nik Ibrahim, Mohd Abd Wahab Yusof
    MyJurnal
    A study to assess the concentration of radionuclides in spent resins of the PUSPATI TRIGA Mark II reactor coolant purification system has been carried out. Fresh spent resins collected and analysed in May 2010, after the changing of leaked heat exchanger in Sept. 2009 was found to contain 24Na, 122Sb, 51Cr, 124Sb, 58Co, 65Zn, 54Mn and 60Co. Old spent resins removed in 2001 and 2002 but analysed in 2010 indicated the presence of 60Co and 152Eu as radionuclides with half-lives of < 1 year might have already been decayed out. These results can be used to establish radionuclide inventory of the spent resins as part of radiation protection programme.
  10. Muhamat Omar, Zalina Laili, Abd Khalik Wood, Julia Abdul Karim, Zarina Masood, Mohd Fazli Zakaria, et al.
    MyJurnal
    A systematic study to assess the concentration of radionuclides in primary coolant and associated water samples from the operation of a TRIGA Mark II reactor has been carried out. The samples were transferred into appropriate counting container and were counted by efficiency-calibrated gamma spectrometer systems for several hours to obtain statistically adequate data for qualitative and quantitative evaluation of the radioactive materials presence. The primary coolant was found to contain various gamma emitting radionuclides including 24Na, 41Ar, 42K, 51Cr, , 54Mn, 56Mn, 60Co, 99mTc, 122Sb, 124Sb and 187W. Most of the detected radionuclides were inferred to be originated from activation products of (n,) nuclear reactions of elements of reactor components such as stainless steel and aluminium alloy used in the reactor system. The study confirms the integrity of the reactor system with no apparent release of any fission products radionuclide into the coolant water system.
  11. Shamsiah Abdul Rahman, Md Suhaimi Elias, Nazaratul Ashifa Abdullah Salim, Zalina Laili, Azian Hashim, Shakirah Abd Shukor, et al.
    MyJurnal
    Samples of fine (PM2.5) and coarse (PM10-2.5) fraction of airborne particulate were collected on weekly basis during the period from May 2012 to July 2014 at Bangi, Selangor. The samples were collected using a Gent Stacked Filter Sampler in two fractions of < 2.5 µm and 2.5 - 10 µm sizes. This research paper aims at establishing the concentration level of PM2.5, PM10-2.5 and PM10 at Bangi area and investigates their possible sources and contribution to the ambient aerosol of the area. The samples were analyzed for their elemental composition and black carbon content by Particle Induced X-ray Emission (PIXE) and Smoke Stain Reflectometer, respectively. The average for PM2.5, PM10-2.5 and PM10 ranged from1.8 µg/m3 to 78.0 µg/m3, 9.6 µg/m3 to 76.8 µg/m3 and 12 µg/m3 to 134 µg/m3, respectively. Positive Matrix Factorization (PMF) technique was also applied to fine and coarse data set in order to identify the possible sources of particulate matter (PM) and their contribution to the ambient particulate matter concentrations in the area. The best solution was found to be five factors for both elemental compositions of fine and coarse PM, respectively. The PMF results show that motor vehicles and secondary sulphate contribute about 40.3% and 33.0% of the fine mass respectively followed by soil, sea salt and smoke/biomass burning with the average contribution of 10.5%, 10.3% and 6.4%, respectively. In case of coarse particles the PMF results show that a large fraction of about more than 50% of the coarse mass comes from motor vehicle. Soil dust including road dust and soil construction contribute about 32.5% of the coarse mass whilst the smoke/biomass burning factor contributes about 6.7% of the coarse mass.
Filters
Contact Us

Please provide feedback to Administrator (afdal@afpm.org.my)

External Links