This study investigated the influence of paraquat, a prevalent poison used by suicides, on initial oviposition and development of Chrysomya megacephala (Fabricius) using minced-beef substrates. Paraquat in lethal dose for human (40 mg/kg), two times the lethal dose (80 mg/kg) and five times the lethal dose (200 mg/kg) were mixed thoroughly with respective minced-beef substrates (1 kg each) that were decomposed in a shaded habitat fully protected from rain. Results of four replications of the above experiment revealed that the presence of paraquat neither delayed initial oviposition nor prolonged the developmental stages of C. megacephala. Therefore, estimation of postmortem interval (PMI) based on empirical baseline data obtained using animal models devoid of any poisons would still be appropriate for estimating PMI in paraquat-related deaths.
The likelihood of dipteran maggots colonizing a corpse due to nocturnal oviposition can be used to challenge the postmortem interval (PMI) estimated assuming diurnal oviposition. Earlier experiments tested nocturnal oviposition behavior by exposing fresh baits once during a single night. In this pilot study, oviposition behavior was studied using beef baits, which, simulating the decay of the body seen in case situations, decomposed inside cages designed to open and close at scheduled intervals during consecutive night or twilight periods. Freshly hatched maggots from diurnally oviposited eggs emerged in control baits on the third day, while a limited number of maggots attributable to nocturnal or twilight oviposition were observed in experimental baits only on the fifth or sixth day, indicating a categorical delay. These results suggest that such delayed and limited nocturnal oviposition is not forensically significant since the larger maggots deriving from diurnal oviposition would be the ones considered when estimating PMI.
In the daily practice of forensic pathology, sudden cardiac death (SCD) is a diagnostic challenge. Our aim was to determine the usefulness of blood biomarkers [creatine kinase CK-MB, myoglobin, troponins I and T (cTn-I and T), and lactate dehydrogenase] measured by immunoassay technique, in the postmortem diagnosis of SCD. Two groups were compared, 20 corpses with SCD and 8 controls. Statistical significance was determined by variance analysis procedures, with a post hoc Tukey multiple range test for comparison of means (p < 0.05). SCD cases showed significantly higher levels (p < 0.05) of cTn-T and cTn-I compared to the control group. Although only cases within the first 8 h of postmortem interval were included, and the control group consisted mainly of violent death cases, our results suggest that blood troponin levels may be useful to support a diagnosis of SCD.
Recent advances in imaging technologies, such as intra-oral surface scanning, have rapidly generated large datasets of high-resolution three-dimensional (3D) sample reconstructions. These datasets contain a wealth of phenotypic information that can provide an understanding of morphological variation and evolution. The geometric morphometric method (GMM) with landmarks and the development of sliding and surface semilandmark techniques has greatly enhanced the quantification of shape. This study aimed to determine whether there are significant differences in 3D palatal rugae shape between siblings. Digital casts representing 25 pairs of full siblings from each group, male-male (MM), female-female (FF), and female-male (FM), were digitized and transferred to a GM system. The palatal rugae were determined, quantified, and visualized using GMM computational tools with MorphoJ software (University of Manchester). Principal component analysis (PCA) and canonical variates analysis (CVA) were employed to analyze palatal rugae shape variability and distinguish between sibling groups based on shape. Additionally, regression analysis examined the potential impact of shape on palatal rugae. The study revealed that the palatal rugae shape covered the first nine of the PCA by 71.3%. In addition, the size of the palatal rugae has a negligible impact on its shape. Whilst palatal rugae are known for their individuality, it is noteworthy that three palatal rugae (right first, right second, and left third) can differentiate sibling groups, which may be attributed to genetics. Therefore, it is suggested that palatal rugae morphology can serve as forensic identification for siblings.
This study presents a wavelet analysis of resultant velocity features belonging to genuine and forged groups of signature sample. Signatures of individuals were initially classified based on visual human perceptions of their relative sizes, complexities, and legibilities of the genuine counterparts. Then, the resultant velocity was extracted and modeled through wavelet analysis from each sample. The wavelet signal was decomposed into several layers based on maximum overlap discrete wavelet transform (MODWT). Next, the zero crossing rate features were calculated from all the high wavelet sub-bands. A total of seven hypotheses were then tested using a two-way ANOVA testing methodology. Of these, four hypotheses were conducted to test for significance differences between distributions. In addition, three hypotheses were run to provide test for interaction between two factors of signature authentication versus perceived classification. The results demonstrated that both feature distributions belonging to genuine and forged groups of samples cannot be distinguished by themselves. Instead, they were significantly different under the influence of two other inherent factors, namely perceived size and legibility. Such new findings are useful information particularly in providing bases for forensic justifications in establishing the authenticity of handwritten signature specimens.
Lipstick can be an important piece of evidence in crimes like murders, rapes, and suicides. Due to its prevalence, it can be an important corroborative evidence in crime reconstruction. The analysis of such evidence can provide an evidentiary link between the suspect, the victim, object, or the crime scene. We report the use of nondestructive ATR-FTIR spectroscopy combined with chemometrics for the classification of 10 brands of lipsticks with nine samples each. Chemometric method of partial least square-discriminant analysis (PLS-DA) has been employed to interpret the data and classify the samples into their respective classes. The PLS-DA model provides an AUC figure above 0.99 in all brands except one; for which it is slightly less at 0.94. We have also tested the traces of these lipstick samples on different substrates treating them as unknowns in the already trained PLS-DA model. 100% of the samples on nine substrates viz. a cotton, nylon, plastic, dry tissue, denim (blue jeans), wet tissue, nitrile gloves, white paper, and polyester were correctly attributed to their source brand. In conclusion, the results suggest that ATR-FTIR combined with the chemometrics is a rapid, nondestructive, and accurate method for the discrimination and source attribution of lipstick. This study has potential for use in actual forensic casework conditions.
Wing shape variation has been shown to be useful for delineating forensically important fly species in two Diptera families: Calliphoridae and Sarcophagidae. Compared to DNA-based identification, the cost of geometric morphometric data acquisition and analysis is relatively much lower because the tools required are basic, and stable softwares are available. However, to date, an explicit demonstration of using wing geometric morphometric data for species identity prediction in these two families remains lacking. Here, geometric morphometric data from 19 homologous landmarks on the left wing of males from seven species of Calliphoridae (n = 55), and eight species of Sarcophagidae (n = 40) were obtained and processed using Generalized Procrustes Analysis. Allometric effect was removed by regressing centroid size (in log10 ) against the Procrustes coordinates. Subsequently, principal component analysis of the allometry-adjusted Procrustes variables was done, with the first 15 principal components used to train a random forests model for species prediction. Using a real test sample consisting of 33 male fly specimens collected around a human corpse at a crime scene, the estimated percentage of concordance between species identities predicted using the random forests model and those inferred using DNA-based identification was about 80.6% (approximate 95% confidence interval = [68.9%, 92.2%]). In contrast, baseline concordance using naive majority class prediction was 36.4%. The results provide proof of concept that geometric morphometric data has good potential to complement morphological and DNA-based identification of blow flies and flesh flies in forensic work.
Conventional dental age estimation relies on destructive methods such as sectioning and staining, which are unpreferable when the tooth is required for evidential or archeological preservation. MicroCT is a non-destructive, high-resolution imaging technique that allows for accurate morphometrical measurement. Although microCT technology has been applied in a variety of dental studies, studies focusing on dental age-related change and dental age estimation based on microCT imaging remain lacking. Based on the question: "How has microCT technology been applied in studying human age-related tooth morphological change and dental age estimation studies?", the authors conducted a scoping review in accordance with the Arksey and O'Malley (2005) and the PRISMA-ScR guidelines. A literature search using five major scientific databases identified 452 articles, with 11 full-text articles being eligible to be included in the scoping review. Furthermore, 6 out of the 11 studies performed dental age estimation modeling. An overview of the parameters used in the selected articles revealed a variety of tooth characteristics, such as pulp cavity to whole tooth volume ratio, secondary dentin, as well as the diameter of root canal orifice. The findings of this scoping review highlight the extent microCT is used in studying dental age-related changes, as well as the effectiveness of microCT in dental age estimation studies. This review serves as a guide for future forensic odontology age estimation studies.
Manual ground searches and cadaver dogs are traditional methods for locating remains, but they can be time- and resource-intensive, resulting in the decomposition of bodies and delay in victim identification. Therefore, thermal imaging has been proposed as a potentially useful tool for detecting remains based on their temperature. This study investigated the potential of a novel search technique of thermal drones to detect surface remains through the detection of maggot mass temperatures. Two trials were carried out at Selangor, Malaysia, each utilizing 12 healthy male Oryctolagus cuniculus European white rabbits and DJI Matrice 300 RTK drone China, equipped with a thermal camera; Zenmuse H20T to record the thermal imaging footage of the carcasses at various heights (15, 30, 60-100 m) for 14 days for each trial. Our results demonstrated that the larval masses and corresponding heat emissions were at their largest during the active decay stage; therefore, all the carcasses were observable in thermal images on day 5 and remained until day 7. Statistical analyses showed that (1) no statistically significant differences in thermal images between clothed and unclothed subjects (p > 0.05); (2) 15 m above ground level was proven to be the optimal height, as it showed the greatest contrast between the carcass heat signature and the background (p
A body of an unknown adult female was found within a shallow burial ground in Malaysia whereas the skull was exposed and visible on the ground. During autopsy examination, nine insect larvae were recovered from the interior of the human skull and subsequently preserved in 70% ethanol. The larvae were greyish in appearance, each with a posterior elongated breathing tube. A week after the autopsy, more larvae were collected at the burial site, and some of them were reared into adults. Adult specimens and larvae from the skull and from the burial site were sequenced to obtain DNA barcodes. Results showed all adult flies reared from the burial site, as well as the larvae collected from the skull were identified as Eristalinus arvorum (Fabricius, 1787) (Diptera: Syrphidae). Here, we report the colonization of E. arvorum larvae on a human corpse for the first time.
Paraquat poisoning is commonly associated with suicide or homicide in Malaysia. In a case involving advanced body decomposition, pathological analysis regarding the cause of death may become difficult or almost impossible. Insects serve as common alternative matrix for poison detection in forensic analysis. Paraquat detection via secondary bioaccumulation in fly larvae tissue has never been reported. In this study, tissues from blowfly larvae collected from a rabbit carcass with paraquat poisoning were analyzed for secondary bioaccumulation. Larvae samples were collected and analyzed using liquid-liquid extraction. The detection was performed via reduction of quaternary ammonium presence in paraquat and analyzed using gas chromatography-mass spectrometry (GC-MS) with selected ion monitoring mode (SIM mode). GC-MS showed the elution of reduced paraquat was at retention time 12.8 min. Blowfly larvae tissue has proven useful as a secondary detector in paraquat-related deaths.
Although there is clinical applicability of the palatal rugae as an identification tool in forensic odontology, controversy exists whether the palatal rugae patterns are stable or variable. The greater the genetic component, the higher the probability that palatal rugae patterns are stable. The aim of this study was to compare the palatal rugae morphology between full siblings and the proportion of variability due to genetic component. This cross-sectional study was conducted on digital models of 162 siblings aged 15-30 years old. The palatal rugae patterns were assessed with Thomas and Kotze (1983) classification using Geomagic Studio software (3D Systems, Rock Hill, SC). The palatal rugae morphology between siblings showed significantly similar characteristics for total number of left rugae (p = 0.001), left primary rugae (p = 0.017), secondary rugae for right (p = 0.024) and left sides (p = 0.001), right straight rugae (p = 0.010), and right convergent rugae (p = 0.005) accounting for at least 6.25%-12.8% of the variability due to heredity. Despite the similarities found, the palatal rugae patterns showed significant differences between siblings of at least 46.9% (p = 0.001). Zero heritability was found in 9 of the 14 rugae patterns. Meanwhile, total number of rugae, primary, backward, and convergent rugae showed moderate heritability (h2 > 0.3) and total number of secondary rugae showed high heritability (h2 > 0.6). In conclusion, despite the individuality characteristics, an appreciable hereditary component is observed with significant similarities found between sibling pairs and the palatal rugae patterns were both environmentally and genetically influenced.
The onus of proof in criminal cases is beyond any reasonable doubt, and the issue on the lack of complete internal validation data can be manipulated when it comes to justifying the validity and reliability of the X-chromosomal short tandem repeats analysis for court representation. Therefore, this research evaluated the efficiency of the optimized 60% reduced volumes for polymerase chain reaction (PCR) amplification using the Qiagen Investigator® Argus X-12 QS Kit, as well as the capillary electrophoresis (CE) sample preparation for blood samples on Flinder's Technology Associates (FTA) cards. Good-quality DNA profile (3000-12,000 RFU) from the purified blood sample on FTA card (1.2 mm) were obtained using the optimized PCR (10.0 μL of PCR reaction volume and 21 cycles) and CE (9.0 μL Hi-Di™ Formamide and 0.3 μL DNA Size Standard 550 [BTO] and 27 s injection time) conditions. The analytical and stochastic thresholds were 100 and 200 RFU, respectively. Hence, the internal validation data supported the use of the optimized 60% reduced PCR amplification reaction volume of the Qiagen Investigator® Argus X-12 QS Kit as well as the CE sample preparation for producing reliable DNA profiles that comply with the quality assurance standards for forensic DNA testing laboratories, while optimizing the analytical cost.
This article presents an analysis of handwritten signature dynamics belonging to two authentication groups, namely genuine and forged signature samples. Genuine signatures are initially classified based on their relative size, graphical complexity, and legibility as perceived by human examiners. A pool of dynamic features is then extracted for each signature sample in the two groups. A two-way analysis of variance (ANOVA) is carried out to investigate the effects and the relationship between the perceived classifications and the authentication groups. Homogeneity of variance was ensured through Bartlett's test prior to ANOVA testing. The results demonstrated that among all the investigated dynamic features, pen pressure is the most distinctive which is significantly different for the two authentication groups as well as for the different perceived classifications. In addition, all the relationships investigated, namely authenticity group versus size, graphical complexity, and legibility, were found to be positive for pen pressure.