This study aims to optimize sequential ultrasound-microwave assisted extraction (UMAE) on pomelo peel using citric acid. The effects of pH, sonication time, microwave power and irradiation time on the yield and the degree of esterification (DE) of pectin were investigated. Under optimized conditions of pH 1.80, 27.52min sonication followed by 6.40min microwave irradiation at 643.44W, the yield and the DE value of pectin obtained was respectively at 38.00% and 56.88%. Based upon optimized UMAE condition, the pectin from microwave-ultrasound assisted extraction (MUAE), ultrasound assisted extraction (UAE) and microwave assisted extraction (MAE) were studied. The yield of pectin adopting the UMAE was higher than all other techniques in the order of UMAE>MUAE>MAE>UAE. The pectin's galacturonic acid content obtained from combined extraction technique is higher than that obtained from sole extraction technique and the pectin gel produced from various techniques exhibited a pseudoplastic behaviour. The morphological structures of pectin extracted from MUAE and MAE closely resemble each other. The extracted pectin from UMAE with smaller and more regular surface differs greatly from that of UAE. This has substantiated the highest pectin yield of 36.33% from UMAE and further signified their compatibility and potentiality in pectin extraction.
Low methoxyl (LM) pectin was extracted from pomelo peels using subcritical water in a dynamic mode. The effects of pressure and temperature were analyzed through a face-centred central composite design. Extraction yield and the rate of extraction were found to be predominantly influenced by temperature. Optimization of the subcritical water extraction (SWE) yielded an optimized operating condition of 120°C and 30bar with a predicted pectin yield of 18.8%. The corresponding experimental yield was 19.6%, which is in close agreement with the predicted data. The pectin obtained from the optimized condition was further analyzed for its physicochemical properties. The kinetics of the SWE was also evaluated whereby the one-site kinetic desorption model was found to be in good agreement with experimental data (R2>0.94).