Standard prosthodontic procedures require five visits to construct a set of complete maxillary and mandibular dentures. Various attempts have been made to reduce these procedures to four or three appointments. However, most of these techniques require the use of visible light polymerized resin as the final denture base materials. Visible light-cured resin materials have inferior physical properties and biocompatibility problems as compared with heat cured polymethylmethacrylate. This paper describes a system of complete denture construction which requires three clinical appointments instead of the usual five visits. This system is made possible by using the VLC base/tray material as the preliminary impression material as well as the application of a new biometric wax occlusion rim. It retains the use of polymethylmethacrylate as the denture base material. This system also utilizes all the procedures used in the conventional five appointment system of complete denture construction.
Besides other indications, the spring cantilever bridge can solve the difficult clinical problem of providing diastema on either side of a pontic. Unlike the conventional bridges, it has a somewhat controversial design in that the anterior pontic is connected to its retainer on a posterior abutment by a relatively long flexible palatal bar. This paper presents a case report of a spring bridge which fractured due to metal fatigue after 30 years of continued service. Other studies reported a mean life span of 8-10 years for conventional bridges. The advantages of the spring cantilever bridge are also discussed.
This is a preliminary survey on cast partial denture designs in the commercial dental laboratories. This survey was carried out for a month in three commercial dental laboratories in Klang Valley and Shah Alam which produce metal dentures in cobalt-chromium. One hundred and ten questionnaires with the designs were collected and analysed. The framework design on the cast was transferred into the design sheet section of the questionnaire. The aim was to investigate communication regarding denture design between clinicians and dental technician and the dentists' dependency on the technician. The design of cobalt-chromium partial dentures in relation to oral health was also assessed. The results indicated that 43.6% of the dentist who used the three laboratories delegated their removable partial design work to the dental technician. More than half of the dentists had some communication with the technicians, and only 18.2 % of the dentists prescribed clear instructions with details of components regarding denture design. Continuing dental education on partial denture design for both clinicians and dental technicians would be of value to provide reinforcement in the knowledge of the basic concept on denture designing. Communication and understanding between both parties would probably improve the quality of cobalt-chromium dentures constructed.