Dental rehabilitation of a completely edentulous geriatric patient has always been a challenge to the clinician, especially in treating those with higher expectations and demands. Treatment duration and the amount of residual alveolar bone available are often important considerations when planning for dental implant-based fixed treatment for these patients. With the introduction of zygomatic implants, a graftless alternative solution has emerged for deficient maxillary bone with provision for immediate loading. This article describes the treatment of a completely edentulous elderly patient using zygomatic implants in conjunction with conventional implants. The implants were immediately loaded using a definitive acrylic resin fixed denture reinforced with a cast metal framework, to provide function and aesthetics.
Thirty-one patients treated at the Faculty of Dentistry, University of Malaya, were assessed for their satisfaction following orthognathic surgery. The female to male ratio was 22:9 with an age range of 17 to 36. Almost all patients (97%) listed appearance as one of their rationales for surgery. More males (78%) than females (59%) wanted functional improvement, while more females (91%) than males (33%) hoped for improvement in self-confidence. All patients reported esthetic improvement while 68% each reported improvement in mastication and self-confidence. Slightly more than half (52%) chose esthetic improvement as the single most important factor resulting in satisfaction. Almost ninety percent of male patients claimed satisfaction with functional improvement, while 68% of those who found satisfaction in improved self-confidence were females. Eighty-seven percent rated their post-surgical changes as being well accepted by their family. The impact of these findings on the success of the surgery and the need to reinforce verbal communication with printed pamphlets are emphasized.
Passive fit of a long-span screw-retained implant prosthesis is an important criteria for the success of the restoration. This article describes a technique for fabricating a ceramometal implant fixed dental prosthesis (FDP) for a long-span partially edentulous situation by altering the conventional screw-retained design. The possibility of a passive fit is maximized by intraoral luting of the cast frame to milled abutments, and the potential framework distortion during fabrication is compensated to a major extent. Retrievability is ensured by screw retention of the prosthesis to the implants. Compared with conventional porcelain fused to metal screw-retained FDP, this prosthesis is relatively inexpensive to fabricate.