Carbon capture and storage (CCS) involves capturing, transporting and storing CO2 geologically underground permanently. Carbon capture using solvent such as amine and aqueous ammonia has been extensively studied by many researchers. However, this capture technology for CCS scheme is costly. As an alternative, CO2 emission can be cost-effectively captured and stored by utilizing the well-understood natural photosynthetic process of marine cyanobacteria. In contrast, the capturing process using cyanobacteria is very slow compared to the chemical absorption mentioned prior. Hence, this study aimed to investigate carbon capturing and storing process using integrated aqueous ammonia and mutated marine cyanobacteria (Synechococcus PCC 7002 IIUM01). The conditions that can maximize CO2 reduction under various conditions; CO2 flow rate (Lpm), absorption temperature (C) and aqueous ammonia concentrations (% (w/v)) were to be identified. The effectiveness of the mutant cyanobacteria was quantified by measuring the cell concentration, percentage reduction in CO2 concentration and lipid content. Synechococcus PCC 7002 IIUM01 showed it robustness by growing in aqueous ammonia solution at the concentration of 0.5 to 1% (w/v) at which the parent strain was not able to tolerate. The best conditions in maximizing CO2 capture and storage while sustaining growth optimally and being a potential biofuel source was observed at 0.5 Lpm of 15% CO2 gas flow rate, 0.75% (w/v) of ammonia concentration and 33C of absorption temperature. At this specified condition, around 68% of CO2 removal was achieved with 9% (w/w) yield of lipid and more than 13% (w/v) of cell concentration obtained.
Single-node leafy stem cuttings of Shorea leprosula Miq. were subjected to a high, intermediate or low irradiance treatment for 16 weeks in an enclosed mist propagation system. Before rooting, maximum photosynthesis of the cuttings occurred at an irradiance of 400 micro mol m(-2) s(-1). Although none of the irradiance treatments affected the number of roots produced per cutting, the numbers of cuttings that formed roots were 50 and 30% in the high irradiance (diurnal range of 0-658 micro mol m(-2) s(-1)) and low irradiance (diurnal range of 0-98 micro mol m(-2) s(-1)) treatments, respectively, compared with 62% in the intermediate irradiance treatment (diurnal range of 0-360 micro mol m(-2) s(-1)). Low rooting frequency of cuttings in the high irradiance treatment was associated with water deficits (maximum leaf-to-air vapor pressure deficit (VPD) = 3.6 kPa), whereas cuttings in the low irradiance treatment had a low rooting frequency because they were below the light compensation point most of the time. In the intermediate irradiance treatment, cuttings withstood a daily maximum VPD of 1-2 kPa and recovered overnight from the previous day's deficit, as indicated by higher relative water content (RWC) and stomatal conductance (g(s)) in the morning than in the previous afternoon and evening. Higher RWC and g(s) of cuttings in all treatments on Days 14 and 21 compared with Day 8 probably indicated recovery from water deficit following severance and insertion of the cuttings in rooting medium. There were negative relationships between stem volume of cuttings and both number of cuttings that rooted and number of roots per cutting.
13 selected purslane accessions were subjected to five salinity levels 0, 8, 16, 24, and 32 dS m(-1). Salinity effect was evaluated on the basis of biomass yield reduction, physiological attributes, and stem-root anatomical changes. Aggravated salinity stress caused significant (P < 0.05) reduction in all measured parameters and the highest salinity showed more detrimental effect compared to control as well as lower salinity levels. The fresh and dry matter production was found to increase in Ac1, Ac9, and Ac13 from lower to higher salinity levels but others were badly affected. Considering salinity effect on purslane physiology, increase in chlorophyll content was seen in Ac2, Ac4, Ac6, and Ac8 at 16 dS m(-1) salinity, whereas Ac4, Ac9, and Ac12 showed increased photosynthesis at the same salinity levels compared to control. Anatomically, stem cortical tissues of Ac5, Ac9, and Ac12 were unaffected at control and 8 dS m(-1) salinity but root cortical tissues did not show any significant damage except a bit enlargement in Ac12 and Ac13. A dendrogram was constructed by UPGMA based on biomass yield and physiological traits where all 13 accessions were grouped into 5 clusters proving greater diversity among them. The 3-dimensional principal component analysis (PCA) has also confirmed the output of grouping from cluster analysis. Overall, salinity stressed among all 13 purslane accessions considering biomass production, physiological growth, and anatomical development Ac9 was the best salt-tolerant purslane accession and Ac13 was the most affected accession.
Palm oil mill effluent contains carcinogenic coloured compounds that are difficult to separate due to their aromatic structure. Though colour treatment using adsorption processes at lower pH (<4) have been reported effectual, due to its acidity the remediated effluent poses an environmental hazard as a result. Thus, the current study focused on achieving decolourization at neutral pH by enhancing the morphology of the coconut shell activated carbon (CSAC) using N₂ as activating-agent with microwave irradiation heating. The microwave pretreated and non-pretreated CSAC were characterized using scanned electron microscopy (SEM), energy dispersive X-ray (EDX) and Brunauer-Emmett-Teller (BET) analysis. A significant modification in the porous structure with a 66.62% increase in the specific surface area was achieved after the pretreatment. The adsorption experimental matrix was developed using the central composite design to investigate the colour adsorption performance under varied pH (6⁻7), dosage (2⁻6 g) and contact time (10⁻100 min). At optimum conditions of neutral pH (7), 3.208 g dosage and contact time of 35 min, the percentage of colour removal was 96.29% with negligible differences compared with the predicted value, 95.855%. The adsorption equilibrium capacity of 1430.1 ADMI × mL/g was attained at the initial colour concentration of 2025 ADMI at 27 °C. The experimental data fitted better with the Freundlich isotherm model with R² 0.9851.
Forest growth is an important factor both economically and ecologically, and it follows a predictable trend with age. Generally, growth accelerates as canopies develop in young forests and declines substantially soon after maximum leaf area is attained. The causes of this decline are multiple and may be linked to age- or size-related processes, or both. Our objective was to determine the relative effects of tree age and tree size on the physiological attributes of two broadleaf species. As age and size are normally coupled during growth, an approach based on grafting techniques to separate the effects of size from those of age was adopted. Genetically identical grafted seedlings were produced from scions taken from trees of four age classes, ranging from 4 to 162 years. We found that leaf-level net photosynthetic rate per unit of leaf mass and some other leaf structural and biochemical characteristics had decreased substantially with increasing size of the donor trees in the field, whereas other gas exchange parameters expressed on a leaf area basis did not. In contrast, these parameters remained almost constant in grafted seedlings, i.e., scions taken from donor trees with different meristematic ages show no age-related trend after they were grafted onto young rootstocks. In general, the results suggested that size-related limitations triggered the declines in photosynthate production and tree growth, whereas less evidence was found to support a role of meristematic age.