In some parts of tropical Africa, termite mound locations are traditionally used to site groundwater structures mainly in the form of hand-dug wells with high success rates. However, the scientific rationale behind the use of mounds as prospective sites for locating groundwater structures has not been thoroughly investigated. In this paper, locations and structural features of termite mounds were mapped with the aim of determining the aquifer potential beneath termite mounds and comparing the same with adjacent areas, 10 m away. Soil and species sampling, field surveys and laboratory analyses to obtain data on physical, hydraulic and geo-electrical parameters from termite mounds and adjacent control areas followed. The physical and hydraulic measurements demonstrated relatively higher infiltration rates and lower soil water content on mound soils compared with the surrounding areas. To assess the aquifer potential, vertical electrical soundings were conducted on 28 termite mounds sites and adjacent control areas. Three (3) important parameters were assessed to compute potential weights for each Vertical Electrical Sounding (VES) point: Depth to bedrock, aquifer layer resistivity and fresh/fractured bedrock resistivity. These weights were then compared between those of termite mound sites and those from control areas. The result revealed that about 43% of mound sites have greater aquifer potential compared to the surrounding areas, whereas 28.5% of mounds have equal and lower potentials compared with the surrounding areas. The study concludes that termite mounds locations are suitable spots for groundwater prospecting owing to the deeper regolith layer beneath them which suggests that termites either have the ability to locate places with a deeper weathering horizon or are themselves agents of biological weathering. Further studies to check how representative our study area is of other areas with similar termite activities are recommended.
The possible role of cyclic adenosine 3',5'-monophosphate (cAMP) in mediating the action of steroid hormones was investigated using the rat lung. Male rats were adrenalectomized and treated with olive oil, dexamethasone, corticosterone, deoxycorticosterone (DOC) or progesterone. At the end of 10 days, 100 micrograms isoprenaline/kg was injected intraperitoneally 5 min before the animals were killed to stimulate cAMP production. Adrenalectomy significantly decreased cAMP levels in the rat lung. Dexamethasone and corticosterone pretreatment reversed the effect of adrenalectomy whereas progesterone pretreatment but not DOC pretreatment significantly decreased lung cAMP levels. Cyclic AMP levels in normal female rats, whether pregnant or not, were not significantly different from those in male rats. We concluded that the absence of glucocorticoid, as after adrenalectomy, decreased the cAMP levels in rat lungs and that this could be reversed by either dexamethasone or corticosterone replacement. Progesterone reduced the cAMP content in rat lungs by acting as a glucocorticoid antagonist or by acting directly via progesterone receptors.
Despite the importance of strength and power in rugby skills and match outcomes, there exists a noticeable gap in the measurement consistency and estimation of a true change of typical assessments designed to assess these qualities. To address this gap, we investigated the between-session reliability, interrelationships, and minimal detectable changes (MDC) of commonly used strength and power measures in team sports. Sixteen national-level rugby 7 s players were tested on two occasions, one week apart. Both the best and average (of 2-3 trials) peak force, peak power, height, distance, and/or strength indices during countermovement jump (CMJ), drop jump (DJ), isometric mid-thigh pull (IMTP), plyometric push-up (PPU), and standing long jump (SLJ) were obtained. Furthermore, one-repetition maximum (1RM) strength for bench press and back squat, reactive strength index, and dynamic strength index were also determined. Reliability was assessed using intraclass correlation coefficients (ICC) and coefficients of variation (CV), and used for MDC calculations, and interrelationships between variables were determined using correlation coefficients. Reliability was excellent for bench press, back squat, and SLJ (ICCs > 0.91); high to excellent for IMTP peak force, all CMJ, and DJ (except best DJ height and contact time), and PPU peak force parameters (ICCs > 0.78), with < 10% CVs (except PPU peak power). MDCs were generally smaller for average than best values. Large to very large relationships (r = 0.60 to 0.85) were observed between bench press, back squat, and IMTP with selected parameters of CMJ and PPU (p < 0.05), but not in DJ and SLJ. In conclusion, selected measures of strength and power displayed high to excellent reproducibility, with average values (rather than best) offering more stable assessments, and "smaller" MDCs. Based upon the relationships, it can be inferred that maximising strength would likely contribute to enhanced explosive performance.