Aim: This study is aimed at evaluating and comparing the remineralisation of early enamel caries on the occlusal surface of permanent posterior teeth using ICDAS II caries scoring system and DIAGNOdent Pen (DDPen) after remineralisation with Colgate Duraphat® and GC Tooth Mousse Plus®.
Materials and Methods: Extracted posterior teeth (N = 120) with incipient occlusal caries were included in this study. The occlusal surface of each tooth was scored using DDPen and ICDAS II scoring before remineralisation. Then, remineralisation of the teeth of the experimental group was carried out using either CPP-ACP-F or fluoride varnish. After the remineralisation procedures, the occlusal surface of each tooth was again scored using DDPen and ICDAS II scoring. The teeth were then fixed in dental stone blocks and sectioned longitudinally for histological examination using a stereomicroscope. Statistical analysis was performed to calculate the sensitivity and specificity of DDPen and ICDAS II to detect remineralisation and compare with the gold standard histological examination.
Results: According to ICDAS-II scores, a significant difference was noted in GC Tooth Mousse Plus® and Duraphat® study samples, whereas the difference between the pre-and post-remineralisation of the control group was not significant. According to the DDPen score criteria, a statistically significant difference was noted among all study groups; however, a greater significance level was noted in the GC Tooth Mousse Plus® and Duraphat® study samples compared with the control group. The Spearman's rank correlation of ICDAS-II and DDPen with Downer's histological score (gold standard) revealed a higher association of DDPen score (.738) as compared to ICDAS-II scores (.430).
Conclusion: The study concluded that both ICDAS II and DDPen could detect remineralisation of early enamel occlusal caries. DDPen was more sensitive than ICDAS-II to detect remineralisation compared with the Downers histological scores.
METHODS: 71 investigation sites of sound fissure and naturally occurring NCFC on human extracted premolars were identified and scanned with a swept-source OCT. The teeth were then sectioned bucco-lingually at the investigation sites and imaged using PLM. Two calibrated examiners trained on the B-scan NCFC visual interpretation criteria established for this study, assessed the investigation sites and results were validated against PLM.
RESULTS: Detection sensitivity of B-scan for NCFC when fissures were assessed in totality, or on the slopes or walls separately are 0.98, 0.95, 0.94 and specificity are 0.95, 0.90, and 0.95. One-way ANOVA showed that width measurements of wall loci done with OCT and PLM were not statistically different. However, OCT height measurements of slope loci were statistically bigger with a constant bias of 0.08 mm (of which is not clinically significant) and OCT height measurements of wall loci were statistically smaller (0.57 mm) and Bland-Altman plots indicated presence of proportionate bias.
CONCLUSION: Visual assessment of B-scans with the interpretation criteria resulted in both high specificity and sensitivity and were not affected by loci location. OCT width measurement of wall loci is in agreement with PLM.
CLINICAL SIGNIFICANCE: Unanimous high sensitivity in this and previous studies indicate that visual assessment of B-scans reliably rule out NCFC. Detection accuracy was not affected by loci location. Width of wall loci and/or height of slope loci in OCT B-scan are to be used for monitoring NCFC but not height of wall loci.
METHODS: Visible proximal surfaces of extracted human teeth were assessed by ICDAS-II before setting them in five manikin mouth models. Then contacting proximal surfaces in mouth models were assessed by BW and CS. Histological validation with polarized-light microscopy served as a gold standard. Pairwise comparisons were performed on area under the curve (AUC), sensitivity, and specificity of the three methods, and corrected using Bonferroni's method. Sensitivities and specificities were compared using a test of proportions and AUC values were compared using DeLong's method.
RESULTS: The CS presented significantly higher sensitivity (0.933) than ICDAS-II (0.733, P = 0.01) and BW (0.267, P