Energy consumption is an important part of life today because without the power a work cannot be done. The energy used today will be lost or waste without renewable energy or power recycle back. In reality, energy use has always had a noticeable impact on the environment. Overconsumption of energy is the main trigger for the global warming that is now threatening to cause devastation in many areas of the world. Each year, electricity consumption in Malaysia is always an increase. This can contribute to the occurrence of global warming. This project will be designed for renewable energy or recycle power to avoid waste of energy from lost. Also, this project consider regarding the Green Technology without polluting the environment. The objective is to develop a prototype or hardware that aims to renewable energy using the 12V DC Motor as a generator which is use rear shaft of table fan as a medium to drive the 12V DC Motor and also to analyze the power consumption of table fan before and after install with hardware. The methods used to design the connector and DC motor holder is using a solidwork software, then construct the circuit simulation using a proteus software and also use a microcontroller PIC16F877A as a controller. The result obtained from the testing and experiments by integrating the hardware part, electrical part and software part. Finally, with the development of a power recycling prototype for renewable energy using DC Motor application, the wasted energy can be reused from conversion to other energy and energy can be used as renewable energy.