This paper studies about water obtained from fish pond of fisheries research centre. Usual water
quality parameters such as pH, COD, Turbidity and Ammonia content were analyzed before and
after irradiation. Electron beam irradiation was used to irradiate the water with the dose 100 kGy,
200 kGy and 300 kGy. Only high dose was applied on this water as only a limited amount of
samples was supplied. All the parameters indicated a slight increase after irradiation except for the
ammonia content, which showed a gradual decrease as irradiation dose increases. Sample
condition was changed before irradiation in order to obtain more effective results in the following
batch. The water sample from fisheries was diluted with distilled water to the ratio of 1:1.This was
followed with irradiation at 100 kGy, 200 kGy and 300 kGy. The results still showed an increase in
all parameters after irradiation except for ammonia content. For the following irradiation batch,
the pH of the sample was adjusted to pH 4 and pH 8 before irradiation. For this sample the
irradiation dose selected was only 100 kGy. A higher value of ammonia was observed for the
sample with pH 4 after irradiation. Other parameters were almost the same as the first two batches
A laboratory scale test rig to treat simulated flue gas using electron beam technology was installed at the Alurtron EB-Irradiation Center, MINT. The experiment test rig was proposed as a result of feasibility studies conducted jointly by IAEA, MINT and TNB Research in 1997. The test rig system consists of several components, among others, diesel generator sets, pipe ducts, spray cooler, ammonia dosage system, irradiation vessel, bag filter and gas analyzers. The installation was completed and commissioned in October 2001. Results from the commissioning test runs and subsequent experimental work showed that the efficiency of flue gas treatment is high. It was proven that electron beam technology might be applied in the treatment of air pollutants. This paper describes the design and work function of the individual major components as well as the full system function. Results from the initial experimental works are also presented.
The combination of irradiation and biological technique was chosen to study COD, BOD5 and colour removal from textiles effluent in the presence of food industry wastewater. Two biological treatments, the first consisting a mix of non irradiated textile and food industry wastewater and the second a mix of irradiated textiles wastewater and food industry wastewater were operated in parallel. Reduction percentage of COD in textiles wastewater increased from 29.4% after radiation to 62.4% after further undergoing biological treatment. After irradiation, the BOD5 of textiles wastewater was reduced by 22.1%, but reverted to the original value of 36mg/1 after undergoing biological treatment. Colour had decreased from 899.5 ADMI to 379.3 ADM1 after irradiation and continued to decrease to 109.3 ADMI after passing through biological treatment.