Tropical peat swamp forest (PSF) is a unique wetland ecosystem with distinct vegetation types. Due to the waterlogged environment, the stand characteristics in this ecosystem are different from those of other inland forests. This paper highlights stand characteristics of a PSF based on our investigation of a 1 ha ecological plot established in a Virgin Jungle Reserve (VJR) at Compartment 100, Pekan Forest Reserve, Pahang, Malaysia. This site is considered a Gonystylus bancanus-rich area. From the inventory, we recorded a total of 49 tree species from 38 genera and 25 families among all trees of ≥ 10 cm in diameter at breast height. Calophyllum ferrugineum var. ferrugineum was the most abundant species, followed by G. bancanus. The forest appeared healthy, as all tree characteristics (crown shape, log grade and climber infestation) generally fell within Classes 1 and 2 (good and moderate categories), with the exception of crown illumination which majority of the trees were rated as class 3 (received less sunlight). The latter finding indicates that most of the trees living under the canopy received minimal illumination. In terms of total tree biomass, we estimated that about 414.6 tonnes exist in this 1 ha area; this tree biomass is higher than in some PSF areas of Sumatra, Indonesia.
Fused deposition modelling (FDM) has been widely used in medical appliances, automobile, aircraft and aerospace, household appliances, toys, and many other fields. The ease of processing, low cost and high flexibility of FDM technique are strong advantages compared to other techniques for thermoelectric polymer composite fabrication. This research work focuses on the effect of two crucial printing parameters (infill density and printing pattern) on the tensile, dynamic mechanical, and thermoelectric properties of conductive acrylonitrile butadiene styrene/zinc oxide (CABS/ZnO composites fabricated by FDM technique. Results revealed significant improvement in tensile strength and Young's modulus, with a decrease in elongation at break with infill density. Improvement in dynamic storage modulus was observed when infill density changed from 50% to 100%. However, the loss modulus and damping factor reduced gradually. The increase of thermal conductivity was relatively smaller compared to the improvement of electrical conductivity and Seebeck coefficient, therefore, the calculated figure of merit (ZT) value increased with infill density. Line pattern performed better than rectilinear, especially in tensile properties and electrical conductivity. From the results obtained, FDM-fabricated CABS/ZnO showed much potential as a promising candidate for thermoelectric application.