This study investigated the effect of manufacturing process variables of mini-tablets, in particular, the effect of process variables concerning fluidized bed granulation on tablet weight variation. Test granules were produced with different granulation conditions according to a definitive screening design (DSD). The five evaluated factors assigned to DSD were: the grinding speed of the sample mill at the grinding process of the active pharmaceutical ingredient (X1), microcrystalline cellulose content in granules (X2), inlet air temperature (X3), binder concentration (X4) and the spray speed of the binder solution (X5) at the granulation process. First, the relationships between the evaluated factors and the granule properties were investigated. As a result of the DSD analysis, the mode of action of granulation parameters on the granule properties was fully characterized. Subsequently, the variation in tablet weight was examined. In addition to mini-tablets (3 mm diameter), this experiment assessed regular tablets (8 mm diameter). From the results for regular tablets, the variation in tablet weight was affected by the flowability of granules. By contrast, regarding the mini-tablets, no significant effect on the variation of tablet weight was found from the evaluated factors. From this result, this study further focused on other important factors besides the granulation process, and then the effect of the die-hole position of the multiple-tip tooling on tablet weight variation was proven to be significant. Our findings provide a better understanding of manufacturing mini-tablets.
The application of time-domain NMR (TD-NMR) analysis to quantify water content in pharmaceutical ingredients is demonstrated. The initial phase of the study employed a range of disintegrants with defined amounts of added water (0-30% of the total weight) as samples; the disintegrants included croscarmellose sodium, corn starch, low-substituted hydroxypropyl cellulose, and crospovidone. After acquisition of the T2 relaxation curves of the samples by TD-NMR measurements, these curves were analyzed by partial least squares (PLS) regression. According to the analysis, accurate and reliable PLS models were created that enabled accurate assessment of water content in the samples. A powder blend consisting of acetaminophen (paracetamol) and tablet excipients was also examined. Both a physical mixture of the powder blend and a wet granule prepared with a high-speed granulator were tested as samples in this study. Precise determination of water content in the powder blend was achieved by using the TD-NMR method. The accuracy of water content determination was equivalent to or better than that of the conventional loss on drying method. TD-NMR analysis samples were measured nondestructively and rapidly with low cost; thus, it could be a powerful quantitative method for determining water content in pharmaceuticals.