The influence of an anionic surfactant, a cationic surfactant, and salinity on adsorbed methane (CH4) in shale was assessed and modeled in a series of systematically designed experiments. Two cases were investigated. In case 1, the crushed Marcellus shale samples were allowed to react with anionic sodium dodecyl sulfate (SDS) and brine. In case 2, another set of crushed Marcellus shale samples were treated with cetyltrimethylammonium bromide (CTAB) and brine. The surfactant concentration and salinity of brine were varied following the Box-Behnken experimental design. CH4 adsorption was then assessed volumetrically in the treated shale at varying pressures (1-50 bar) and a constant temperature of 30 °C using a pressure equilibrium cell. Mathematical analysis of the experimental data yielded two separate models, which expressed the amount of adsorbed CH4 as a function of SDS/CTAB concentration, salinity, and pressure. In case 1, the highest amount of adsorbed CH4 was about 1 mmol/g. Such an amount was achieved at 50 bar, provided that the SDS concentration is kept close to its critical micelle concentration (CMC), which is 0.2 wt %, and salinity is in the range of 0.1-20 ppt. However, in case 2, the maximum amount of adsorbed CH4 was just 0.3 mmol/g. This value was obtained at 50 bar and high salinity (∼75 ppt) when the CTAB concentration was above the CMC (>0.029 wt %). The findings provide researchers with insights that can help in optimizing the ratio of salinity and surfactant concentration used in shale gas fracturing fluid.
Energy has a significant influence on Malaysia's industry. It is used in electricity generation, refineries, gas processing plants and end-user applications such as transportation, residential, agriculture and fishing. These burning fossil fuel activities produce greenhouse gases (GHG) emissions. This article presents the emissions data of fuel used in power plants in Malaysia during the year of 1990 until 2017. The fuel used in power plants is coal and coke, natural gas, diesel oil and residual fuel oil. The energy data used in power plants were gathered from the Malaysia Energy Information Hub, published by the Malaysian Energy Commission. The GHG emissions data were calculated using the emission factors method. The climate impact of different GHGs in terms of CO2-equivalent (CO2-e) was also calculated using global warming potentials. The article also presents population data in Malaysia during the year. A correlation between the fuels, GHG emission and the population is also investigated using statistical analysis. The data presented here may facilitate the Malaysian government to identify the source of the pollutants and undertake a climate change mitigation plan.
This study aimed to determine the distribution and potential health risks of polycyclic aromatic hydrocarbons (PAHs) in PM2.5 collected in Kuala Lumpur during different monsoon seasons. The potential sources of PM2.5 were investigated using 16 priority PAHs with additional of biomass tracers namely levoglucosan (LV), mannosan (MN) and galactosan (GL). This study also investigated the cytotoxic potential of the extracted PAHs towards V79-4 cells. A high-volume air sampler (HVS) was used to collect PM2.5 samples for 24 h. PAHs were extracted using dichloromethane (DCM) while biomass tracers were extracted by a mixture of DCM/methanol (3:1) before analysis with gas chromatography-mass spectrometry (GC-MS). The cytotoxicity of the PAHs extract was determined by assessing the cell viability through the reduction of tetrazolium salts (MTT). The results showed that the total mean ± SD concentrations of PAHs during the southwest (SW) and northeast (NE) monsoons were 2.51 ± 0.93 ng m-3 and 1.37 ± 0.09 ng m-3, respectively. Positive matrix factorization (PMF) using PAH and biomass tracer concentrations suggested four potential sources of PM2.5; gasoline emissions (29.1%), natural gas and coal burning (28.3%), biomass burning (22.3%), and diesel and heavy oil combustion (20.3%). Health risk assessment showed insignificant incremental lifetime cancer risk (ILCR) of 2.40E-07 for 70 years of exposure. MTT assay suggested that PAHs extracts collected during SW monsoon have cytotoxic effect towards V79-4 cell at the concentrations of 25 μg mL-1, 50 μg mL-1, 100 μg mL-1 whereas non-cytotoxic effect was observed on the PAHs sample collected during NE monsoon.
Malaysia is the world’s third largest exporter of liquified natural gas and the second largest oil and natural gas producer in Southeast Asia, following Indonesia. The potential air pollutants released from the industry may affect the health of the population. The primary objective of this study was to determine the potential health risk among the population in the zone of impact. This was a comparative case study between controlled and uncontrolled emissions based on the air dispersion modelling. Hazard quotient (HQ) was used to assess non-carcinogenic risk, while lifetime cancer risk (LCR) was used to assess carcinogenic risk. All ambient air pollutant levels were within permissible levels and adhered to the standard. The HQ for hydrogen sulphide and benzene was less than one in all scenarios. The LCR for benzene was acceptable in all scenarios. Advanced pollution prevention equipment should be installed within the gas emission system to treat the final emission to meet prescribed permissible limits. Continuous ambient air monitoring and effective control measures should be practiced to ensure the sustainability of clean air. The health risk assessment showed no risk of developing malignancy and non-cancer disorder among the workers and general population living surround the petrochemical plants. This allows the development of the petroleum refinery plants to be continued.