The purpose of the study is to find out the psychological impact of the COVID-19 pandemic on university students. The study focuses on the university students from different public and private universities of Bangladesh through a set of questionnaires according to the guideline of Generalized Anxiety Disorder Scale (GAD-7). The result among 15 543 respondents shows that 44.59% are suffering from severe anxiety, 48.41% moderate anxiety, and only 3.82% mild anxiety. The results highlight that all epidemic-related stressors are positively correlated with the level of anxiety. Among the epidemic-related stressors, worry about economic influences during and after COVID-19 (r = 0.342, p < 0.001) and worry about the influence of COVID-19 on daily life (r = 0.340, p < 0.001) have a highly positive impact on the level of anxiety. Following these stressors, worry about academic delays due to COVID-19 (r = 0.326, p < 0.001) and worry about the social support during COVID-19 (r = 0.321, p < 0.001) have moderately and positively correlated with the level of anxiety. The study suggests that proper government support, as well as social awareness, should be monitored during epidemics for decreasing anxiety and maintaining a good mental health of the university students.
A new series of liquid crystals decorated gold nanoparticles is synthesized whose molecular architecture has azobenzenes moieties as the peripheral units connected to gold nanoparticles (Au NPs) via alkyl groups. The morphology and mesomorphic properties were investigated by field emission scanning electron microscope, high-resolution transmission electron microscopy, differential scanning calorimetry and polarizing optical microscopy. The thiolated ligand molecules (3a-c) showed enantiotropic smectic A phase, whereas gold nanoparticles (5a-c) exhibit nematic and smectic A phase with monotropic nature. HR-TEM measurement showed that the functionalized Au NPs are of the average size of 2nm and they are well dispersed without any aggregation. The trans-form of azo compounds showed a strong band in the UV region at ∼378nm for the π-π(∗) transition, and a weak band in the visible region at ∼472nm due to the n-π(∗) transition. These molecules exhibit attractive photoisomerization behaviour in which trans-cis transition takes about 15s whereas the cis-trans transition requires about 45min for compound 5c. The extent of reversible isomerization did not decay after 10 cycles, which proved that the photo-responsive properties of 5c were stable and repeatable. Therefore, these materials may be suitably exploited in the field of molecular switches and the optical storage devices.
Highly active natural pandanus-extracted cellulose-supported poly(hydroxamic acid)-Cu(II) complex 4 was synthesized. The surface of pandanus cellulose was modified through graft copolymerization using purified methyl acrylate as a monomer. Then, copolymer methyl acrylate was converted into a bidentate chelating ligand poly(hydroxamic acid) via a Loosen rearrangement in the presence of an aqueous solution of hydroxylamine. Finally, copper species were incorporated into poly(hydroxamic acid) via the adsorption process. Cu(II) complex 4 was fully characterized by Fourier transform infrared (FTIR), field emission scanning electron microscopy (FE-SEM), energy-dispersive X-ray (EDX), transmission electron microscopy (TEM), inductively coupled plasma optical emission spectrometry (ICP-OES), thermogravimetric analysis (TGA), X-ray diffraction (XRD), and X-ray photoelectron spectroscopy (XPS) analyses. The cellulose-supported Cu(II) complex 4 was successfully applied (0.005 mol %) to the Ullmann etherification of aryl, benzyl halides, and phenacyl bromide with a number of aromatic phenols to provide the corresponding ethers with excellent yield [benzyl halide (70-99%); aryl halide (20-90%)]. Cu(II) complex 4 showed high stability and was easily recovered from the reaction mixture. It could be reused up to seven times without loss of its original catalytic activity. Therefore, Cu(II) complex 4 can be commercially utilized for the preparation of various ethers, and this synthetic technique could be a part in the synthesis of natural products and medicinal compounds.
Mesoporous silica supported adsorbents have been used towards metal ion removal from water due to their thermally stability and good sorption capacity. Thus, mesoporous silica-based methyl acrylate monomer (Silica-APTES-DPNO) was converted into hydroxamic acid (SBHA) by using oximation reaction and all products are analyzed by by FT-IR. The SBHA showed satisfactory binding properties with copper, cobalt, nickel and lead are 242, 206, 195 and 516 mg g-1, respectively, with the batch adsorption system was set to pH 6. The kinetics of metal ions binding obeyed the pseudo-1st-order process up to 60 min. In this study also consider the Langmuir and Freundlich isotherm to find out the sorption behavior. The isotherm study demonstrated the well fit with Freundlich isotherm (R² > 0.99). Thus, adsorption take place as a multilayer system, therefore, SBHA material is useful for the metal ions removal from water.
Ion-imprinting polymers (IIPs) materials draw the great recognition because of the powerful selectivity to the desired metal ions. Therefore, the ion-imprinting polymer (Ce-IIP) was prepared by using cerium metal with amidoxime ligand as the complexing agent, in addition ethylene glycol dimethacrylate (EGDMA) and 2,2-azobisisobutyronitrile (AIBN) are crosslinking agent and free radical initiator, respectively. Aqueous HCl was applied to leach the cerium ions from the imprinted polymer for the creation of cavities of template, which is utilized for further cerium ions adsorption with high selectivity. The Ce-IIP was characterized by using ICP-MS, FE-SEM and also solid state analysis by UV-vis NIR spectroscopy. FT-IR study confirmed the complexation of the Ce-IIP was successful. The optimum pH was found to be 6 and the highest adsorption capacity was estimated about 145 mg g-1. Thus, the prepared Ce-IIP gave very good selectivity to cerium ions in the presence of lanthanide ions and also Ce-IIP can be reused 10 times without a substantial loss in adsorption capacity.
Antimitotic colchicine possesses low therapeutic index due to high toxicity effects in non-target cell. However, diverse colchicine analogs have been derivatized as intentions for toxicity reduction and structure-activity relationship (SAR) studying. Hybrid system of colchicine structure with nontoxic biofunctional compounds modified further affords a new entity in chemical structure with enhanced activity and selectivity. Moreover, nanocarrier formulation strategies have been used for colchicine delivery. This review paper focuses on colchicine nanoformulation, chemical synthesis of colchicine prodrugs and codrugs with different linkers, highlights linker chemical nature and biological activity of synthesized compounds. Additionally, classification of colchicine prodrugs based on type of conjugates is discussed, as biopolymers prodrugs, fluorescent prodrug, metal complexes prodrug, metal-labile prodrug and bioconjugate prodrug. Finally, we briefly summarized the biological importance of colchicine nanoformulation, colchicine prodrugs and codrugs.
Corn-cob cellulose supported poly(hydroxamic acid) Cu(II) complex was prepared by the surface modification of waste corn-cob cellulose through graft copolymerization and subsequent hydroximation. The complex was characterized by IR, UV, FESEM, TEM, XPS, EDX and ICP-AES analyses. The complex has been found to be an efficient catalyst for 1,3-dipolar Huisgen cycloaddition (CuAAC) of aryl/alkyl azides with a variety of alkynes as well as one-pot three-components reaction in the presence of sodium ascorbate to give the corresponding cycloaddition products in up to 96% yield and high turn over number (TON 18,600) and turn over frequency (TOF 930h-1) were achieved. The complex was easy to recover from the reaction mixture and reused six times without significant loss of its catalytic activity.
The number of older women are increasing more rapidly and it is estimated that by 2050, the number of elderly women over 60 years old will be 3.2 times that of 2000. Moreover, the number and rate of elderly women in cities where widowed life alone has increased. The study pays attention to the fragile and vulnerable group of urban elderly women. Hence, the purpose of the study to suggest psychological adjustment and guidance for ageing urban women. The study suggests that by adopting protective policies and measures in a targeted manner this problem can be resolved. It is not only a critical responsibility of the state and the government, but also the social responsibility of all sectors of society, including enterprises and non-profit sectors of society, and even every ordinary citizen to support the elderly women for making their rest of lives happier and enjoyable.
This paper explores optimization strategies for polymeric materials in organic solar cells (OSCs) with the focus on varying alkyl side chain, addition of fluorine atom, and thiophenated derivatives onto polymer. As such, it outlines the significance of renewable energy sources and the potential of photovoltaic technologies, particularly organic photovoltaics (OPVs). Objectives include factors affecting power conversion efficiency (PCE), open-circuit voltage (Voc), aggregation tendencies, and optoelectronic properties in OPVs. The scope encompasses the impact of alkyl as well as the comparison between fluorinated and chlorinated polymers and the role of thiophene units to obtain an efficient organic solar cell. The review examines how alkyl chain structures influence thin film morphology, packing, and device performance, comparing linear and branched configurations. It also explores the role of halogenated polymers in modifying electronic properties and stability, focusing on the comparative performance between fluorinated and chlorinated polymers. The importance of thiophene units in polymer design for OPVs is discussed, along with performance comparisons based on different architectures. The paper summarizes key findings regarding the impact of various side chain modifications for OPVs device performance and outlines future research directions to enhance efficiency, stability, and scalability. It suggests exploring novel material design to further optimize OSCs.
In this work, the photocatalytic property of p-type CuO was tailored by creating a heterojunction with n-type CdS. The CuO/CdS nanocomposite photocatalyst was synthesized by the ultrasound-assisted-wet-impregnation method and the physicochemical and optical properties of the catalysts were evaluated by using N2 physisorption, X-Ray Diffraction (XRD),X-Ray Photoelectron Spectroscopy (XPS), Raman spectroscopy, Transmission electron microscopy (TEM), Energy dispersive X-Ray (EDX) mapping, Field Emission Scanning Electron Microscope (FE-SEM), UV-Vis and photoluminescence spectroscopy experiments. Detailed characterization revealed the formation of a nanocomposite with a remarkable improvement in the charge carrier (electron/hole) separation. The photocatalytic degradation efficiencies of CuO and CuO/CdS were investigated for different dyes, for instance, rhodamine B (RhB), methylene blue (MLB), methyl blue (MB) and methyl orange (MO) under visible light irradiation. The obtained dye degradation efficiencies were ~93%, ~75%, ~83% and ~80%, respectively. The quantum yield for RhB degradation under visible light was 6.5 × 10-5. Reusability tests revealed that the CuO/CdS photocatalyst was recyclable up to four times. The possible mechanisms for the photocatalytic dye degradation over CuO/CdS nanocomposite were elucidated by utilizing various scavengers. Through these studies, it can be confirmed that the conduction band edges of CuO and CdS play a significant role in producing O2-. The produced O2- degraded the dye molecules in the bulk solution whereas the valence band position of CuO acted as the water oxidation site. In conclusion, the incorporation of CuO with CdS was demonstrated to be a viable strategy for the efficient photocatalytic degradation of dyes in aqueous solutions.
A waste material known as palm oil empty fruit bunch (EFB) is used as a source of cellulose for the development of polymeric materials for the removal of metal ions from industrial wastewater. A poly(acrylonitrile)-grafted palm cellulose copolymer was synthesized by a conventional free radical initiating process followed by synthesis of a poly(amidoxime) ligand by oximation reaction. The resulting products were characterized by FT-IR, FE-SEM, EDX, TGA, DSC, and XPS. The poly(amidoxime) ligand was used to coordinate with and extract a series of transition metal ions from water samples. The binding capacity (qe) of the ligand with the metal ions such as copper, iron, cobalt, nickel, and lead were 260, 210, 168, 172, and 272 mg g-1, respectively at pH 6. The adsorption process followed the pseudo-first-order kinetic model (R2 > 0.99) and as well as the Freundlich isotherm model (R2 > 0.99) indicating the occurrence of a multi-layer adsorption process in the amidoxime ligand adsorbent. Results from reusability studies show that the ligand can be recycled for at least 10 cycles without any significant losses to its initial adsorption capacity. The synthesized polymeric ligand was shown to absorb heavy metals from electroplating wastewater with up to 95% efficiency.
The climate of the Earth has changed throughout history. Climate change negatively impacts human rights in a wide range of ways. The study aims to find out the impact of climate change on aging health in developing countries. The study found that public health will be devastated if climate change continues unabated. Countries that are least responsible for global warming are most susceptible to the effects of higher temperatures, such as death and disease. In low- and middle-income countries, disasters are more likely to happen to people aged 60 and over. Although climate change affects all of us, older people are especially at risk from it, as evidenced by a growing body of research. The study also offers countermeasures and suggestions to develop aging health in developing countries affected by climate change.
Corn-cobs are an agro-industrial waste and composed of cellulose mostly. In this study cellulose was isolated from the waste corn-cobs and modified to polymeric hydroxamic acid palladium complex 1 and characterized by using a variety of spectroscopic methods such as field emission scanning electron microscopy (FE-SEM), energy-dispersive X-ray spectroscopy (EDX), transmission electron microscopy (TEM), X-ray powder diffraction (XRD), X-ray photoelectron spectroscopy (XPS) and inductively coupled plasma atomic emission spectroscopy (ICP-AES). The complex 1 exhibited high catalytic activity towards Suzuki and Heck coupling reactions of activated and deactivated aryl halides to give the respective coupling products with high yield. Moreover, the complex 1 was recovered and recycled five times with no considerable loss of catalytic overall performance.