Displaying all 8 publications

Abstract:
Sort:
  1. Tan KT, Lee KT, Mohamed AR
    Bioresour Technol, 2010 Feb;101(3):965-9.
    PMID: 19773156 DOI: 10.1016/j.biortech.2009.09.004
    In this study, fatty acid methyl esters (FAME) have been successfully produced from transesterification reaction between triglycerides and methyl acetate, instead of alcohol. In this non-catalytic supercritical methyl acetate (SCMA) technology, triacetin which is a valuable biodiesel additive is produced as side product rather than glycerol, which has lower commercial value. Besides, the properties of the biodiesel (FAME and triacetin) were found to be superior compared to those produced from conventional catalytic reactions (FAME only). In this study, the effects of various important parameters on the yield of biodiesel were optimized by utilizing Response Surface Methodology (RSM) analysis. The mathematical model developed was found to be adequate and statistically accurate to predict the optimum yield of biodiesel. The optimum conditions were found to be 399 degrees C for reaction temperature, 30 mol/mol of methyl acetate to oil molar ratio and reaction time of 59 min to achieve 97.6% biodiesel yield.
  2. Tan KT, Kannan SK, Rajahram GS
    Med J Malaysia, 2019 12;74(6):547-548.
    PMID: 31929486
    Tuberculosis is a nimble chameleon. It can manifest itself in various ways with atypical clinical and radiographic findings. In this report we discuss the importance of radiographic findings (nodular or mass-like forms) requiring a correlation with microbiological and histopathological results to differentiate lung cancer from TB.
  3. Tang YM, Tan KT, Wong LP
    Water Sci Technol, 2023 Sep;88(6):1404-1416.
    PMID: 37768744 DOI: 10.2166/wst.2023.264
    Residual oil from palm oil mill effluent (POME) can be valorized into value-added products like biofuel. However, the complex structure in POME limits the full recovery of intracellular lipids. To address this challenge, low-frequency ultrasonication was used as a pre-treatment prior to oil recovery to improve the yield by liberating the entrapped oil via the cell disruption technique. This study focused on optimizing the ultrasound conditions (i.e., ultrasonication amplitude, ultrasonication duration, and probe immersion depth) to maximize the improvement of oil recovery yield using response surface methodology. The optimized conditions were 30.074% ultrasonication amplitude, 0.167 min ultrasonication duration, and 2 cm probe immersion depth. This resulted in an additional 42.50% improvement in oil recovery yield over non-ultrasonicated POME, which is in close agreement with the model prediction. Additionally, a cost-benefit analysis was incorporated to determine the feasibility of ultrasonication for enhancing oil recovery. The study also explored the synthesis of biodiesel from POME-recovered oil and characterized the fuel attributes according to American Society for Testing and Materials- and European Standards-prescribed procedures. The attributes of biodiesel produced from POME-recovered oil are comparable to those of palm-based biodiesel in Malaysia, demonstrating its potential as an alternative source for biodiesel production.
  4. Goh CS, Tan KT, Lee KT, Bhatia S
    Bioresour Technol, 2010 Jul;101(13):4834-41.
    PMID: 19762229 DOI: 10.1016/j.biortech.2009.08.080
    The present study reveals the perspective and challenges of bio-ethanol production from lignocellulosic materials in Malaysia. Malaysia has a large quantity of lignocellulosic biomass from agriculture waste, forest residues and municipal solid waste. In this work, the current status in Malaysia was laconically elucidated, including an estimation of biomass availability with a total amount of 47,402 dry kton/year. Total capacity and domestic demand of second-generation bio-ethanol production in Malaysia were computed to be 26,161 ton/day and 6677 ton/day, respectively. Hence, it was proven that the country's energy demand can be fulfilled with bio-ethanol if lignocellulosic biomass were fully converted into bio-ethanol and 19% of the total CO(2) emissions in Malaysia could be avoided. Apart from that, an integrated national supply network was proposed together with the collection, storage and transportation of raw materials and products. Finally, challenges and obstacles in legal context and policies implementation were elaborated, as well as infrastructures shortage and technology availabilities.
  5. Khoo SS, Loi KW, Tan KT, Suhaeb AR, Simmrat S
    Malays Orthop J, 2015 Jul;9(2):57-59.
    PMID: 28435613 MyJurnal DOI: 10.5704/MOJ.1507.003
    Septic arthritis is a surgical emergency. Prompt diagnosis and immediate treatment reduce the destruction of articular cartilage and give better outcome. We describe a simple, minimally invasive closed tube irrigation system for the initial treatment of septic arthritis of the knee in a patient with complex medical problems who was unfit to undergo surgery.
  6. Tan KT, Benedict SLH, Gani YM, Chidambaran SK
    Med J Malaysia, 2022 Sep;77(5):590-596.
    PMID: 36169071
    INTRODUCTION: During the COVID-19 pandemic, bloodstream infection (BSI) rates were substantially rising in Sungai Buloh Hospital (HSB). It is believed that the COVID-19 pandemic has had an adverse impact on BSI incidence caused by contaminated periphery vascular catheters (PVCs). The study's objective is to reduce the BSI rates in HSB by improving adherence to the PVC care bundle via the Plan-Do-Study-Act (PDSA) approach.

    MATERIALS AND METHODS: A quality improvement (QI) project was employed over four months, from June to September 2021, during the COVID-19 pandemic in HSB. All adults hospitalised for COVID-19 with intravenous lines were subjected to data collection. A baseline audit was conducted to study BSI incidence from April to May 2021. Implementation was carried out by PDSA cycles and data on BSI rates per 100 admissions was described using a monthly run chart.

    RESULTS: At baseline, the BSI rate per 100 admissions was 5.44 before implementing our QI project. Initial changes via PDSA cycles did not bring significant improvements to BSI rates and a rising trend in BSI rates was observed after two PDSA cycles. Further audits identified the problem of noncompliance with the practice of aseptic non-touch technique (ANTT) and a lack of effective leadership in implementing the PVC care bundle. The third PDSA cycle focused on adopting practical leadership skills among senior clinicians to ensure compliance with the prevention bundle and to encourage the use of ultrasound guidance for difficult line insertion. After the third PDSA cycle, the BSI rate per 100 admissions was reduced from 6.41 to 4.34 (p < 0.05). The BSI rates continued to decline down the line for another five months.

    CONCLUSION: Through QI initiatives, the risk of BSI can be significantly reduced.

  7. Phoon WH, Goh KT, Lee LT, Tan KT, Kwok SF
    Med J Malaysia, 1983 Mar;38(1):31-4.
    PMID: 6633331
    Two outbreaks involving 31 persons with jaundice are described. All had originally been diagnosed as having viral hepatitis. But subsequent investigations showed that all had been exposed to chloroform at work. Toxic jaundice from chemical exposure presents a similar clinical picture to that of viral hepatitis, but fever appears to be uncommon. Doctors who look after workers should be familiar with the type of work and health hazards of their patients. A knowledge of occupational medicine and epidemiology would enable doctors to help in detecting and preventing
    occupational disease.
  8. Ho JPY, Wong AYF, Ong LH, Rutel A, Abdullah S, Jaffar MSA, et al.
    Geriatr Orthop Surg Rehabil, 2023;14:21514593231164245.
    PMID: 36923160 DOI: 10.1177/21514593231164245
    BACKGROUND: Neck of femur fractures result in impaired function for older people. Despite surgery, many patients experience a decrease in functional level and poorer health status after the injury. The objectives of this study were (1) to determine the short-term mobility and hip function of geriatric patients who underwent hip replacement surgery for a displaced neck of femur fracture in our local population and (2) to identify factors which affect the functional outcome of these patients.

    METHODS: Patients aged 60 years and above, who were admitted for neck of femur fracture from January 2017 to December 2020, and treated surgically with arthroplasty, were included. Information on patient demography, comorbidities, perioperative data, mobility, hip function and complications were retrospectively collected. Outcome measures used were independent ambulation and recovery of pre-fracture mobility at 1 year after surgery while hip function was assessed using the Western Ontario and McMaster Universities Osteoarthritis Index (WOMAC) total, pain, stiffness, and physical function scores. Factors associated with these outcomes were analyzed.

    RESULTS: 168 patients with a mean age of 75.2 (SD 8.4) years met the inclusion criteria. 32.1% of patients regained their pre-fracture mobility and 59.6% remained independent 1 year after surgery. Logistic regression analysis identified age, gender, surgical procedure, and time to surgery as significant contributors to recovery of pre-fracture mobility. Older age and increasing requirement for postoperative ambulatory aid resulted in worse WOMAC total and physical function scores. No significant differences were observed in patient-reported hip function between those who had a total hip arthroplasty and those who had a hemiarthroplasty.

    CONCLUSION: Most geriatric patients with displaced neck of femur fractures did not regain pre-fracture mobility despite surgical treatment with arthroplasty.

Related Terms
Filters
Contact Us

Please provide feedback to Administrator (afdal@afpm.org.my)

External Links