The regulation roles of insulin-like growth factor-1 (IGF-1) with basic fibroblast growth factor (bFGF) and transforming growth factor beta 2 (TGFbeta2) in human nasal septum chondrocytes monolayer culture and cartilage engineering was investigated in this study. The role of IGF-1 with bFGF and TGFbeta2 was investigated by measuring chondrocyte growth kinetic and collagen genes expression. IGF-1 together with bFGF and TGFbeta2 promote cartilage tissue engineering, increase type II collagen expression and enhance the histological features of engineered cartilage.
Autologous cells are usually preferred in treating damaged tissue to avoid risks of immunological rejection and transmitting infectious diseases. Since only limited amount of tissue can be obtained without causing morbidity at the donor site, in vitro expansion of isolated cell is essential in order to acquire sufficient number of cells to reconstruct neocartilage. The aim of this study was to examine whether serial expanded chondrocytes can be use to generate neocartilage in vivo.
Culture media supplemented with animal serum e.g. fetal bovine serum; FBS is commonly used for human culture expansion. However, for clinical application, FBS is restricted as its carry a risk of viral or prion transmission. Engineering autologous cartilage with autologous human serum supplementation is seen as a better solution to reduce the risk of transmitting infectious diseases and immune rejection during cartilage transplantation. The purpose of this study is to establish and compare the effects of 10% autologous human serum (AHS) and 10% FBS on the growth of chondrocytes and the formation of tissue engineered human articular cartilage.
Animal serum is commonly used in chondrocytes culture expansion to promote cell proliferation and shorten the time lag before new tissue reconstruction is possible. However, animal serum is not suitable for regeneration of clinical tissue because it has potential risk of viral and prion related disease transmission particularly mad cow disease and foreign protein contamination that can stimulate immune reaction leading to graft rejection. In this context, human serum as homologous supplement has a greater potential as growth promoting agents for human chondrocytes culture.
Treatment of articular cartilage lesions remains a clinical challenge. The uses of prosthetic joint replace allograft and/or autograft transplant carry a risk of complications due to infection, loosening of its component, immunological rejection and morbidity at the donor site. There has been an increasing interest in the management of cartilage damages, owing to the introduction of new therapeutic options. Tissue engineering as a method for tissue restoration begins to provide a potential alternative therapy for autologous grafts transplantations. We aimed to evaluate how well a tissue engineered neocartilage implant, consist of human articular chondrocytes cultured with the presence of autologous serum and mixed in a fresh fibrin derived from patient, would perform in subcutaneous implantation in athymic mice.
One of the emerging technologies in the area of plasma processing is plasma immersion ion implantation (PSII). The paper addresses the merits offered by the PSII technique especially in the area of biomaterial processing. Worldwide development status as well as the drive towards commercial applications is elaborated in an attempt to draw the attention to the importance of the process for Malaysia as well as south East Asia.
The standard bioglass composition GS45 as well as with excess silica GS50 or with the addition of 5% titanium oxide GS45+Ti5, were prepared by the polymeric route. The different glass components were added to the formed polymer. Firing at 700 degrees C gave an amorphous product with microporous texture that readily crystallizes out at 900 degrees C. The prepared materials were highly porous with two modes of pore system micro-pores and macro-pores with a size ranging between 100 microm to 0.006 microm and a porosity reaching 73%. The measured bulk density was between 0.36 to 1.1g/cm3. The fired material preserved the former structure of the polymer precursor. Biocompatibility was verified in vitro and vivo. IR of the specimens previously immersed in SBF revealed the formation of apatite like layer. While the histology sections of implants in rate femurs showed new bone tissue or bone trabeculae after 21 days.
The appearance of dental porcelains is comparable to natural teeth. This study discusses the effect of Y2O3 addition to the fluorescent property of dental porcelains. The composition of dental porcelains contained Y2O3 as the fluorescent agent and base frit. The combinations of Y2O3 added consist of a series with 0.5, 1.0, 1.5, 2.0 and 2.5 wt% respectively, based on the total composition. In the extreme condition, fluorescent agents are added from 5.0 up to 10.0 wt%. In order to enhance the fluorescent property of dental porcelains, an opacifiying agent, cerium oxide (CeO2) was also added to dental porcelains composition. The fluorescent property was determined using Spectroline EF-1400C/F that emits 240 nm wavelength ultraviolet light. The microstructure was examined by Scanning Electron Microscope (SEM). The result shows that, the fluorescent properties displayed are similar to natural teeth when subjected to ultraviolet light. SEM micrograph was able to show the fluorescent agent dispersed in glass phase. Increasing additions of Y2O3 gave the fluorescent properties near to natural teeth.
The aim of this study was to evaluate the effect of powder-to-liquid ratio on the glass transition temperature (Tg) and the tensile properties of denture base material prepared from poly (methyl methacrylate) (PMMA) and hydroxyapatite (HA) previously treated with 3-trimethoxysilylpropyl methacrylate (gamma-MPS). Specimens for mechanical testing were prepared by adding composites powder (PMMA, BPO and HA) to the monomer (MMA and EGDMA) followed by hand mixing as in dental laboratory description usage. The glass transition temperature was studied by using differential scanning calorimetry (DSC). It was observed that the tensile properties and the Tg were affected by the powder-to-liquid ratio. The mechanical characterization of the materials were performed by using single edge notch-tension (SEN-T) specimens; the fracture toughness was slightly higher in formulation which contained HA filler compared to commercial denture base material.
Linear polymers have been commonly used as dental composite. However the aim of this work is to use hyperbranched polymer in an attempt to produce dental composite. The reason is because the dendritic molecules have shown low viscosity at higher molecular weight compared to the linear counterparts. Therefore, this work attempts to substitute the linear polymer with as much of hyperbranched polymer in the dental composite that would pass the required ISO 4049:1998(E) "Dentistry - Resin-based filling material". Several formulations of dental composites were used, i.e. combinations of linear-linear and linear-hyperbranched polymers for comparison. Following this, physical and mechanical characterisation were conducted based on the ISO standards such as water sorption and water solubility. Other characterisation such as polymerisation shrinkage and Vickers hardness were also evaluated. It was found that different types of resins give different physical and mechanical properties. The maximum achievable hyperbranched polymer, which passes the required ISO standard, that can be incorporated in the linear polymer to form dental composite is 43% wt.
Patient own fibrin may act as the safest, cheapest and immediate available biodegradable scaffold material in clinical 1 tissue engineering. This study investigated the feasibility of using patient own fibrin isolated from whole blood to construct a new human cartilage, skin and bone. Constructed in vitro tissues were implanted on the dorsal part of the nude mice for in vivo maturation. After 8 weeks of implantation, the engineered tissues were removed for histological analysis. Our results demonstrated autologous fibrin has great potential as clinical scaffold material to construct various human tissues.
Our objective is to determine the quality of tissue engineered human skin via immunostaining, RT-PCR and electron microscopy (SEM and TEM). Culture-expanded human keratinocytes and fibroblasts were used to construct bilayer tissue-engineered skin. The in vitro skin construct was cultured for 5 days and implanted on the dorsum of athymic mice for 30 days. Immunostaining of the in vivo skin construct appeared positive for monoclonal mouse anti-human cytokeratin, anti-human involucrin and anti-human collagen type I. RT-PCR analysis revealed loss of the expression for keratin type 1, 10 and 5 and re-expression of keratin type 14, the marker for basal keratinocytes cells in normal skin. SEM showed fibroblasts proliferating in the 5 days in vitro skin. TEM of the in vivo skin construct showed an active fibrocyte cell secreting dense collagen fibrils. We have successfully constructed bilayer tissue engineered human skin that has similar features to normal human skin.
Bone marrow stem cells (BMSC), known for its multipotency to differentiate into various mesenchymal cells such as chodrocyte, osteoblasts, adipocytes, etc, have been actively applied in tissue engineering. BMSC have been successfully isolated from bone marrow aspirate and bone marrow scraping from patients of various ages (13-56 years) with as little as 2ml to 5ml aspirate. BMSC isolated from our laboratory showed the presence of a heterogenous population that showed varying prevalence of surface antigens and the presence of telomerase activity albeit weak. Upon osteogenic induction, alkaline phosphatase activity and mineralization activity were observed.
MeSH terms: Bone Marrow Cells/cytology; Bone Regeneration/physiology; Cell Differentiation/physiology; Humans; Bone Transplantation*; Bone Marrow Transplantation*; Telomerase/metabolism; Tissue Engineering*; Mesenchymal Stem Cell Transplantation*
The strategy used to generate tissue-engineered bone construct, in view of future clinical application is presented here. Osteoprogenitor cells from periosteum of consenting scoliosis patients were isolated. Growth factors viz TGF-B2, bFGF and IGF-1 were used in concert to increase cell proliferation during in vitro cell expansion. Porous tricalcium phosphate (TCP)-hydroxyapatite (HA) scaffold was used as the scaffold to form 3D bone construct. We found that the addition of growth factors, greatly increased cell growth by 2 to 7 fold. TCP/HA proved to be the ideal scaffold for cell attachment and proliferation. Hence, this model will be further carried out on animal trial.
MeSH terms: Bone Regeneration/physiology*; Cell Division/physiology; Collagen/metabolism; Humans; Organ Culture Techniques; Periosteum/cytology*; Bone Transplantation*; Tissue Engineering/methods*; Mesenchymal Stem Cell Transplantation*
This study was designed to evaluate the ability of natural coral implant to provide an environment for marrow cells to differentiate into osteoblasts and function suitable for mineralized tissue formation. DNA content, alkaline phosptatase (ALP) activity, calcium (Ca) content and mineralized nodules, were measured at day 3, day 7 and day 14, in rat bone marrow stromal cells cultured with coral discs glass discs, while cells alone and coral disc alone were cultured as control. DNA content, ALP activity, Ca content measurements showed no difference between coral, glass and cells groups at 3 day which were higher than control (coral disc alone), but there were higher measurement at day 7 and 14 in the cell cultured on coral than on glass discs, control cells and control coral discs. Mineralized nodules formation (both in area and number) was more predominant on the coral surface than in control groups. These results showed that natural coral implant provided excellent and favorable situation for marrow cell to differentiate to osteoblasts, lead to large amount of mineralized tissue formation on coral surface. This in vitro result could explain the rapid bone bonding of coral in vivo.