Displaying all 9 publications

Abstract:
Sort:
  1. Gobi K, Vadivelu VM
    Bioresour Technol, 2014 Jun;161:441-5.
    PMID: 24725384 DOI: 10.1016/j.biortech.2014.03.104
    Aerobic dynamic feeding (ADF) strategy was applied in sequencing batch reactor (SBR) to accumulate polyhydroxyalkanoate (PHA) in aerobic granules. The aerobic granules were able to remove 90% of the COD from palm oil mill effluent (POME). The volatile fatty acids (VFAs) in the POME are the sole source of the PHA accumulation. In this work, 100% removal of propionic and butyric acids in the POME were observed. The highest amount of PHA produced in aerobic granules was 0.6833mgPHA/mgbiomass. The PHA formed was identified as a P (hydroxybutyrate-co-hydroxyvalerate) P (HB-co-HV).
  2. Gobi K, Vadivelu VM
    Bioresour Technol, 2015 Nov;196:731-5.
    PMID: 26235884 DOI: 10.1016/j.biortech.2015.07.083
    The polyhydroxyalkanoate (PHA) accumulation dynamics in aerobic granules that undergo the growth-disintegration cycle were investigated. Four sequencing batch reactors (SBR) were inoculated with aerobic granules at different stages of development (different sizes). Different sizes of aerobic granules showed varying PHA contents. Thus, further study was conducted to investigate the diffusion of substrate and oxygen on PHA accumulation using various organic loading rates (OLR) and aeration rates (AR). An increase in OLR from 0.91 to 3.64kg COD/m(3)day increased the PHA content from 0.66 to 0.87g PHA/g CDW. Meanwhile, an AR increase from 1 to 4L/min only accelerated the maximum PHA accumulation without affecting the PHA content. However, the PHA composition only changes with AR, while the hydroxyvalerate (HV) content increased at a higher AR.
  3. Gobi K, Vadivelu VM
    Bioresour Technol, 2015;189:169-176.
    PMID: 25889804 DOI: 10.1016/j.biortech.2015.04.023
    Polyhydroxyalkanoate (PHA) recovery from aerobic granules was investigated using four cell digestion agents, namely, sodium hypochlorite, sodium hydroxide, acetone and sodium chloride. Simultaneously, the removal of extracellular polymeric substances (EPS) and its effect on PHA yield were investigated. The highest PHA recovery yield was obtained using sodium hypochlorite, accounting for 89% cell dry weight (CDW). The highest PHA was recovered after the sodium hypochlorite completely removed the EPS from the aerobic granules. The average molecular weight (Mw) of the PHA recovered using sodium hypochlorite was 5.31 × 10(5)g/mol with only 1.8% molecular weight degradation. The energy and duration analysis for PHA recovery revealed that the sodium hypochlorite method required the least amount of energy and time at 0.0561 MJ/g PHA and 26 h, respectively. The PHA that was recovered was a P3(HB-co-HV) co-polymer.
  4. Ganesan S, Vadivelu VM
    Bioresour Technol, 2020 Jan;296:122341.
    PMID: 31711905 DOI: 10.1016/j.biortech.2019.122341
    Anammox bacteria can easily undergo starvation due to fluctuations in feed flowrate and concentration in wastewater treatment plants. In this study, we analyzed the effects of different types of storage conditions (presence of ammonium (Ra), nitrite (Rn), hydrazine (Rh), and no substrate (Rc)) in aiding the viability of anammox bacteria during starvation and recovery. After starvation, the bacteria were subjected to a 15-week recovery period. Anammox bacteria showed better results during starvation and recovery in Rh as compared to other conditions. Decay rate values obtained after starvation in Ra, Rn, Rh, and Rc were 0.032/day, 0.042/day, 0.019/day, and 0.037/day, respectively. Meanwhile, µmax values obtained in Rh, Ra, Rn, and Rc on the 15th week of recovery were 0.092, 0.075, 0.011, and 0.067 d-1, respectively. This indicated that the availability of hydrazine helps to reduce the mortality rate of anammox bacteria during starvation and enhances the recovery of anammox process.
  5. Ganesan S, Vadivelu VM
    Chemosphere, 2019 May;223:668-674.
    PMID: 30802832 DOI: 10.1016/j.chemosphere.2019.02.104
    Hydrazine is an intermediate product of the anaerobic ammonium oxidation (Anammox) process where both ammonium and nitrite in wastewater are converted to nitrogen gas by bacteria. In this study the effect of external hydrazine addition (5, 10, 15, and 20 mg/L) on the start-up period of the Anammox process was studied using sequencing batch reactors (SBRs). The SBR with an addition of 10 mg/L hydrazine took only 7 weeks to stabilize and achieve the maximum removal of ammonium and nitrite, whereas the SBR without the addition of hydrazine took 12 weeks. The amount of Heme C extracted from the biomass indicated that externally added hydrazine accelerated the growth of Anammox bacteria and reduced the release of nitrous oxide gas from the reactors.
  6. Vjayan T, Vadivelu VM
    Bioresour Technol, 2017 Dec;245(Pt A):970-976.
    PMID: 28946198 DOI: 10.1016/j.biortech.2017.09.038
    The effects of variable aeration in the famine period on polyhydroxyalkanoate (PHA) accumulation in aerobic granules were investigated. Results showed that regardless of the aeration rates used during famine period, all aerobic granules achieved a similar chemical oxygen demand removal and PHA content. The decrease in famine-period aeration rates accelerated the maximum PHA accumulation together with increase in granular size and settling ability. The PHA-accumulating microorganisms were found to have shifted closer to the surface of the granules when the aeration rate was reduced. Moreover, PHA compositional changes occurred, where the hydroxyvalerate content had increased with the reduction in aeration rate. Ultimately, the results indicate that the requirement of aeration for PHA accumulation in aerobic granules is highly insignificant in the famine phase. PHA production in aerobic granules under zero aeration in the famine period may result in an energy input reduction of up to 74%.
  7. Lim JX, Vadivelu VM
    J Environ Manage, 2014 Dec 15;146:217-225.
    PMID: 25173730 DOI: 10.1016/j.jenvman.2014.07.023
    A sequencing batch reactor (SBR) with a working volume of 8 L and an exchange ratio of 25% was used to enrich biomass for the treatment of the anaerobically treated low pH palm oil mill effluent (POME). The influent concentration was stepwise increased from 5000 ± 500 mg COD/L to 11,500 ± 500 mg COD/L. The performance of the reactor was monitored at different organic loading rates (OLRs). It was found that approximately 90% of the COD content of the POME wastewater was successfully removed regardless of the OLR applied to the SBR. Cycle studies of the SBR show that the oxygen uptake by the biomass while there is no COD reduction may be due to the oxidation of the storage product by the biomass. Further, the growth kinetic parameters of the biomass were determined in batch experiments using respirometer. The maximum specific growth rate (μmax) was estimated to be 1.143 day(-1) while the half saturation constant (Ks) with respect to COD was determined to be 0.429 g COD/L. The decay coefficient (bD) and biomass yield (Y) were found to be 0.131 day(-1) and 0.272 mg biomass/mg COD consumed, respectively.
  8. Ruslan AR, Vadivelu VM
    J Environ Sci (China), 2019 Mar;77:148-155.
    PMID: 30573078 DOI: 10.1016/j.jes.2018.06.023
    The effect of pre-treatment of dewatered sludge using different nitrite concentrations and pH for microbial fuel cell (MFC) application was investigated. The results show that the addition of nitrite was feasible to increase the solubilization rate of the sludge and may reduce mass transfer limitation at the anode. This helped the MFC to reach higher voltage and to generate more power. The higher free nitrous acid (FNA) concentration under the acidic condition helped to increase sludge solubilization. However, under an alkaline condition, during which the FNA concentration was relatively low, the solubilization of the sludge was higher. The highest voltage and power density produced was 390 mV and 153 mW/m2, respectively, with the addition of nitrite at 100 mg-N/L and pH 9. Furthermore, it was found that elevated levels of FNA could inhibit electrogenic bacteria thus reducing power generation.
  9. Kabir Ahmad SF, Kanadasan G, Lee KT, Vadivelu VM
    Crit Rev Biotechnol, 2024 Mar 14.
    PMID: 38485522 DOI: 10.1080/07388551.2024.2317785
    Microalgae-based technology is widely utilized in wastewater treatment and resource recovery. However, the practical implementation of microalgae-based technology is hampered by the difficulty in separating microalgae from treated water due to the low density of microalgae. This review is designed to find the current status of the development and utilization of microalgae biogranulation technology for better and more cost-effective wastewater treatment. This review reveals that the current trend of research is geared toward developing microalgae-bacterial granules. Most previous works were focused on studying the effect of operating conditions to improve the efficiency of wastewater treatment using microalgae-bacterial granules. Limited studies have been directed toward optimizing operating conditions to induce the secretion of extracellular polymeric substances (EPSs), which promotes the development of denser microalgae granules with enhanced settling ability. Likewise, studies on the understanding of the EPS role and the interaction between microalgae cells in forming granules are scarce. Furthermore, the majority of current research has been on the cultivation of microalgae-bacteria granules, which limits their application only in wastewater treatment. Cultivation of microalgae granules without bacteria has greater potential because it does not require additional purification and can be used for border applications.
Filters
Contact Us

Please provide feedback to Administrator (afdal@afpm.org.my)

External Links