Enhancing the radiation dose detection sensitivity of optical fibres

Bradley DA 1 , Mahdiraji GA 2 , Ghomeishi M 3 , Dermosesian E 3 , Adikan FR 3 , Rashid HA 4 Show all authors , Maah MJ 5

Affiliations 

  • 1 Department of Physics, University of Surrey, Guildford GU2 7XH, UK; Department of Physics, Faculty of Science, University of Malaya, 50603 Kuala Lumpur, Malaysia
  • 2 Integrated Lightwave Research Group, Department of Electrical Engineering, Faculty of Engineering, University of Malaya, 50603 Kuala Lumpur, Malaysia. Electronic address: ghafouram@gmail.com
  • 3 Integrated Lightwave Research Group, Department of Electrical Engineering, Faculty of Engineering, University of Malaya, 50603 Kuala Lumpur, Malaysia
  • 4 Faculty of Engineering, Center for Photonics and Electronic Devices, Multimedia University, Cyberjaya 63100, Selangor, Malaysia
  • 5 Department of Chemistry, Faculty of Science, University of Malaya, 50603 Kuala Lumpur, Malaysia
Appl Radiat Isot, 2015 Jun;100:43-9.
PMID: 25533626 DOI: 10.1016/j.apradiso.2014.12.005

Abstract

A method for improving the thermoluminescence (TL) yield of silica-based optical fibres is demonstrated. Using silica obtained from a single manufacturer, three forms of pure (undoped) fibre (capillary-, flat-, and photonic crystal fibre (PCF)) and two forms of Ge-doped fibre (capillary- and flat-fibre) were fabricated. The pure fibre samples were exposed to 6 and 21MeV electrons, the doped fibres to 6MV photons. The consistent observation of large TL yield enhancement is strongly suggestive of surface-strain defects generation. For 6MeV irradiations of flat-fibre and PCF, respective TL yields per unit mass of about 12.0 and 17.5 times that of the undoped capillary-fibre have been observed. Similarly, by making a Ge-doped capillary-fibre into flat-fibre, the TL response is found to increase by some 6.0 times. Thus, in addition to TL from the presence of a dopant, the increase in fused surface areas of flat-fibres and PCF is seen to be a further important source of TL. The glow-curves of the undoped fibres have been analysed by computational deconvolution. Trap centre energies have been estimated and compared for the various fibre samples. Two trap centre types observed in capillary-fibre are also observed in flat-fibre and PCF. An additional trap centre in flat-fibre and one further trap centre in PCF are observed when compared to capillary fibre. These elevated-energy trap centres are linked with strain-generated defects in the collapsed regions of the flat fibre and PCF.

* Title and MeSH Headings from MEDLINE®/PubMed®, a database of the U.S. National Library of Medicine.

MeSH terms
Similar publications