Affiliations 

  • 1 Department of Mechanical Systems Engineering, Tohoku University, Aoba-ku Sendai, 980-8579, Japan
  • 2 Micro System Integration Center, Tohoku University, Aoba-ku Sendai, 980-8579, Japan
  • 3 Fakulti Kejuruteraan Pembuatan, Universiti Teknikal Malaysia Melaka, 76100, Durian Tunggal, Melaka, Malaysia
  • 4 Department of Mechanical Systems Engineering, Tohoku University, Aoba-ku Sendai, 980-8579, Japan. ono@nme.mech.tohoku.ac.jp
Nanoscale Res Lett, 2021 Apr 20;16(1):64.
PMID: 33877472 DOI: 10.1186/s11671-021-03524-z

Abstract

Porous silicon (Si) is a low thermal conductivity material, which has high potential for thermoelectric devices. However, low output performance of porous Si hinders the development of thermoelectric performance due to low electrical conductivity. The large contact resistance from nonlinear contact between porous Si and metal is one reason for the reduction of electrical conductivity. In this paper, p- and n-type porous Si were formed on Si substrate by metal-assisted chemical etching. To decrease contact resistance, p- and n-type spin on dopants are employed to dope an impurity element into p- and n-type porous Si surface, respectively. Compared to the Si substrate with undoped porous samples, ohmic contact can be obtained, and the electrical conductivity of doped p- and n-type porous Si can be improved to 1160 and 1390 S/m, respectively. Compared with the Si substrate, the special contact resistances for the doped p- and n-type porous Si layer decreases to 1.35 and 1.16 mΩ/cm2, respectively, by increasing the carrier concentration. However, the increase of the carrier concentration induces the decline of the Seebeck coefficient for p- and n-type Si substrates with doped porous Si samples to 491 and 480 μV/K, respectively. Power factor is related to the Seebeck coefficient and electrical conductivity of thermoelectric material, which is one vital factor that evaluates its output performance. Therefore, even though the Seebeck coefficient values of Si substrates with doped porous Si samples decrease, the doped porous Si layer can improve the power factor compared to undoped samples due to the enhancement of electrical conductivity, which facilitates its development for thermoelectric application.

* Title and MeSH Headings from MEDLINE®/PubMed®, a database of the U.S. National Library of Medicine.