METHODS: This study compares the effects of spray drying, freeze drying, drum drying, vacuum oven drying, and convection oven drying on the physicochemical properties of Bintangor orange powder, including vitamin C and total carotenoid content. The physicochemical properties analyzed for the powders were color analysis, moisture content, water activity, hygroscopicity, degree of caking, wettability, flowability, water solubility index, and bulk density.
RESULTS: Our results showed that freeze dried and convection oven dried powders retained their color so that the powder was the same as the original puree. All powders used in this showed an acceptable moisture content level, with a range of 2.11–2.31%. Spray dried and drum dried powders had the lowest value of moisture content and water activity. Moreover, spray dried powders showed the lowest value in hygroscopicity and bulk density and took the shortest time to wet the powder. The highest solubility and flowability properties were 12.99%, 0.39 g/mL, 18.39 s, 96.08%, and 19.17°, respectively. However, the freeze drying method retained the highest value for both nutritional pigments of vitamin C and total carotenoid content, 18.31 mg/g and 91.32 μg/g, respectively.
CONCLUSIONS: Freeze drying is the most suitable drying method with favorable powder properties compared to spray drying, drum drying, vacuum oven drying and convection oven drying.
RESULTS: The gas pressure for CIR-HAD was higher centrally and decreased gradually towards the surface of the product. This implies that drying force is stronger at the product core than at the product surface. A phase change from liquid water to vapour occurs almost immediately after the start of the drying process for CIR-HAD. The evaporation rate, as expected, was observed to increase with increased drying time. Evaporation during CIR-HAD increased with increasing distance from the centreline of the sample surface. The simulation results of water and vapour flux revealed that moisture transport around the surfaces and sides of the sample is as a result of capillary diffusion, binary diffusion, and gas pressure in both the vertical and horizontal directions. The nonuniform dominant infrared heating caused the heterogeneous distribution of product temperature. These results suggest that CIR-HAD of food occurs in a non-uniform manner with high vapour and water concentration gradient between the product core and the surface.
CONCLUSIONS: This study provides in-depth insight into the physics and phase changes of food during CIR-HAD. The multiphase model has the advantage that phase change and impact of CIR-HAD operating parameters can be swiftly quantified. Such a modelling approach is thereby significant for further development and process optimization of CIR-HAD towards industrial upscaling. © 2020 Society of Chemical Industry.
RESULTS: Numerical optimization showed that rice noodles prepared with SPI, 68.32 (g kg-1 of rice flour), MTG, 5.06 (g kg-1 of rice flour) and GDL, 5.0 (g kg-1 of rice flour) gave the best response variables; hardness (53.19 N), springiness (0.76), chewiness (20.28 J), tensile strength (60.35 kPa), and cooking time (5.15 min). The pH, sensory, and microstructure results showed that the optimized rice noodles had a more compact microstructure with fewer hollows, optimum pH for MTG action, and overall sensory panelists also showed the highest preference for the optimized formulation, compared to other samples selected from the numerical optimization and desirability tests.
CONCLUSION: Optimization of the levels of SPI, MTG, and GDL yielded quality noodles with improved textural, mechanical, sensory, and microstructural properties. This was partly due to the favourable pH value of the optimized noodles that provided the most suitable conditions for MTG crosslinking and balanced electrostatic interaction of proteins. © 2020 Society of Chemical Industry.
RESULTS: All aqueous enzymatic extraction (AEE)-based methods generally resulted in oil with better oxidative properties and higher tocopherol retention than the use of solvent. Prior to AEE, boiling pre-treatment deactivated the hydrolytic enzymes and preserved the oil's quality. In contrast, high-pressure processing (HPP) pre-treatment accelerated hydrolytic reaction and resulted in an increase in free fatty acids after 140 days at all temperatures. No significant changes were detected in the oils' iodine values and fatty acid composition. The tocopherol content decreased significantly at both 13 and 25 °C after 60 days in the oil from SE method, and after 120 days in oils from AEE-based methods.
CONCLUSION: These findings are significant in highlighting the extraction methods resulting in crude MO kernel oil with greatest oxidative stability in the storage conditions tested. Subsequently, the suitable storage condition of the oil prior to refining can be determined. Further studies are recommended in determining the suitable refining processes and parameters for the MO kernel oil prior to application in variety food products. © 2019 Society of Chemical Industry.
METHODS: A full factorial design (23) was applied to study the effects of mango-pineapple ratio (x1), immersion time in sugar solution (x2), and concentration of sugar solution (x3) in the production of mango-pineapple jelly spheres using frozen reverse spherification. The responses studied were the physicochemical properties (color, total soluble solids, and texture) and sensory evaluation of mango-pineapple jelly spheres.
RESULTS: Mango-pineapple ratio had a positive effect on a* and b* while having a negative effect L* value on the jelly sphere. Total soluble solids of jelly spheres were influenced by both immersion time in sugar solution and concentration of sugar solution. Immersion time in sugar solution had a positive effect on the peak force of the compression cycle and deformation at peak load while having a negative effect on the total soluble solid of jelly spheres. On the other hand, the concentration of sugar solution had a positive effect on the sensory evaluation in terms of flavor, texture, and overall acceptability. The desirability function approach was used to optimize the factors, and an overall desirability of 0.89 for all responses was achieved with 1.28:1 mango-pineapple ratio, 30 mins immersion time in sugar solution, and 22°Brix sugar solution. A proximate analysis of the optimized mango-pineapple jelly spheres had an energy content of 73.18 kcal/100 g and showed nutrient values of 81.11% moisture, 0.10% ash, 0.46% protein, 0% fat, 0.97% total dietary fiber, and 17.35% digestible carbohydrate.
CONCLUSIONS: The development of the optimal mango-pineapple jelly sphere allows food producers to produce a dessert that is low in calories, with a good appearance and consumer acceptability.