In this paper, the electrical, dielectric, Raman and small angle X-ray scattering (SAXS) structure behavior of disposed transformer oil in the presence of multi-walled carbon nanotube (MWCNT) were systematically tested to verify their versatility for preparing better alternative transformer oil in future. MWCNT nanofluids are prepared using a two-step method with concentrations ranging from 0.00 to 0.02 g/L. The test results reveal that 0.005 g/L concentration possesses the most optimum performance based on the electrical (AC breakdown and lightning impulse) and dielectric (permittivity, dissipation factor and resistivity) behavior. According to the trend of AC breakdown strength and lightning impulse pattern, there were 212.58% and 40.01% enhancement indicated for 0.005 g/L concentration compared to the disposed transformer oil. The presence of MWCNT also yielding to the decrement of dissipation factor, increased on permittivity and resistivity behavior of disposed transformer oil which reflected to the performance of electrical properties. Furthermore, it is found that these features correlated to the structural properties as systematically verify by Raman and SAXS analysis study.
Copolymers of acrylamide with the sodium salt of 2-acrylamido-2-methylpropane sulfonic acid-known as sulfonated polyacrylamide polymers-had been shown to produce very promising results in the enhancement of oil recovery, particularly in polymer flooding. The aim of this work is to develop an empirical model through the use of a design of experiments (DOE) approach for bulk viscosity of these copolymers as a function of polymer characteristics (i.e., sulfonation degree and molecular weight), oil reservoir conditions (i.e., temperature, formation brine salinity and hardness) and field operational variables (i.e., polymer concentration, shear rate and aging time). The data required for the non-linear regression analysis were generated from 120 planned experimental runs, which had used the Box-Behnken construct from the typical Response Surface Methodology (RSM) design. The data were collected during rheological experiments and the model that was constructed had been proven to be acceptable with the Adjusted R-Squared value of 0.9624. Apart from showing the polymer concentration as being the most important factor in the determination of polymer solution viscosity, the evaluation of the model terms as well as the Sobol sensitivity analysis had also shown a considerable interaction between the process parameters. As such, the proposed viscosity model can be suitably applied to the optimization of the polymer solution properties for the polymer flooding process and the prediction of the rheological data required for polymer flood simulators.
This paper investigates the phase behavior and mutual interactions between a light crude oil and CO2 at high pressures and high temperatures (HPHT). To do so, we have measured PVT properties of the CO2-oil system at HPHT using a PVT setup. We have also tried to present a detailed methodology for measuring PVT properties of CO2-oil systems and highlight the difficulties such as oil vaporization by CO2 during the experiments. A crude oil sample, collected from a Malaysian oil field, was used here. Our experiments indicated that, CO2 solubility in the oil increased at higher pressures when measured at a fixed temperature. Our experiments also showed that increasing the test temperature would reduce CO2 solubility in the oil, while its effect is more significant at higher pressures. The swelling factor (SF) measurements showed an increasing trend with pressure up to a certain value so-called extraction pressure, at which, the SF started to be reduced even became less than one. The measurements of oil viscosity indicated that CO2 dissolution in the oil sample could reduce the mixture viscosity up to 61%. The interfacial tensions between CO2 and the crude oil at different pressures were also measured while the results were used to estimate the minimum miscibility pressure (MMP) and the first contact miscibility (FCM) pressure. The IFT measurements at various pressures displayed a reduction trend as a result of more CO2 dissolution in the oil but with two different slopes. That is, at lower pressure values, the measured IFTs were sharply reduced with pressure, while the reduction rate of the IFT became less when pressures exceeded the extraction pressure. This study helps with determining the optimum pressure and temperature conditions of CO2-oil systems to have a minimum IFT, a maximum CO2 solubility and SF, and a minimum oil viscosity that are favorable for CO2-enhanced oil recovery projects. Additionally, the methodology presented here gives guidelines on how to design PVT experiments of CO2-oil systems for petroleum and chemical engineering applications.
The effect of chemical reaction and variable viscosity on mixed convection heat and mass transfer for Hiemenz flow over a porous wedge plate was studied in the presence of heat radiation. The wall of the wedge was embedded in a uniform Darcian porous medium to allow for possible fluid wall suction or injection and had a power-law variation of both the wall temperature and concentration. The fluid was assumed to be viscous and incompressible. Numerical calculations were carried out for different values of dimensionless parameters and an analysis of the results obtained showed that the flow field was influenced appreciably by the buoyancy ratio between species, thermal diffusion and suction/injection at wall surface. The effects of these major parameters on the transport behaviours were investigated methodically and typical results illustrated to reveal the tendency of the solutions. Representative results are presented for the velocity, temperature, and concentration distributions. Comparisons with previously published works were performed and excellent agreement between the results were obtained. It is predicted that this research might prove to be useful for study of the movement of oil or gas and water through the reservoir of an oil or gas field, in the migration of underground water, in filtration, and water purification processes.
The effect of chamber pressure of a freeze dryer on essential oil contents, drying kinetics, drying characteristics lemon balm leaves and morphology of lemon balm glandular trichomes (oil reservoirs) were investigated. It was found that overall freeze drying (FD) carried out at high (FD-HP) and low pressure (FD-LP) settings consist of sublimation rate, first falling rate and second falling rate periods. Drying rate of FD-LP dried Lemon Balm leaves are higher than FD-HP dried samples, where the drying rates ranged from 0.063 to 0.449 g H2O/ g DM. s and 0.0365 to 0.395 g H2O/ g DM. s, respectively. 3rd order Polynomial model was found to be the best fit model for both drying kinetics. In terms of product quality, eight (8) major constituents of lemon balm leaves essential oil were quantified. Further to this, electro-microscope was used to observe the peltate glandular hairs structure. Product quality analysis showed that FD-HP retained higher amount of essential oil, shape of glandular hairs, but no positive effect on the freeze drying duration.
Recently, nano-EOR has emerged as a new frontier for improved and enhanced oil recovery (IOR & EOR). Despite their benefits, the nanoparticles tend to agglomerate at reservoir conditions which cause their detachment from the oil/water interface, and are consequently retained rather than transported through a porous medium. Dielectric nanoparticles including ZnO have been proposed to be a good replacement for EOR due to their high melting point and thermal properties. But more importantly, these particles can be polarized under electromagnetic (EM) irradiation, which provides an innovative smart Nano-EOR process denoted as EM-Assisted Nano-EOR. In this study, parameters involved in the oil recovery mechanism under EM waves, such as reducing mobility ratio, lowering interfacial tensions (IFT) and altering wettability were investigated. Two-phase displacement experiments were performed in sandpacks under the water-wet condition at 95°C, with permeability in the range of 265-300 mD. A crude oil from Tapis oil field was employed; while ZnO nanofluids of two different particle sizes (55.7 and 117.1 nm) were prepared using 0.1 wt. % nanoparticles that dispersed into brine (3 wt. % NaCl) along with SDBS as a dispersant. In each flooding scheme, three injection sequential scenarios have been conducted: (i) brine flooding as a secondary process, (ii) surfactant/nano/EM-assisted nano flooding, and (iii) second brine flooding to flush nanoparticles. Compare with surfactant flooding (2% original oil in place/OOIP) as tertiary recovery, nano flooding almost reaches 8.5-10.2% of OOIP. On the other hand, EM-assisted nano flooding provides an incremental oil recovery of approximately 9-10.4% of OOIP. By evaluating the contact angle and interfacial tension, it was established that the degree of IFT reduction plays a governing role in the oil displacement mechanism via nano-EOR, compare to mobility ratio. These results reveal a promising way to employ water-based ZnO nanofluid for enhanced oil recovery purposes at a relatively high reservoir temperature.
Microbial diversity within formation water and oil from two compartments in Bokor oil reservoir from a Malaysian petroleum oil field was examined. A total of 1,056 16S rRNA gene clones were screened from each location by amplified ribosomal DNA restriction analysis. All samples were dominated by clones affiliated with Marinobacter, some novel Deferribacteraceae genera and various clones allied to the Methanococci. In addition, either Marinobacterium- or Pseudomonas-like operational taxonomic units were detected from either compartment. A systematic comparison with the existing pertinent studies was undertaken by analysing the microbial amplicons detected and the PCR primers used. The analyses demonstrated that bacterial communities were site specific, while Archaea co-occurred more frequently. Amplicons related to Marinobacter, Marinobacterium and Pseudomonas were detected in a number of the studies examined, suggesting they may be ubiquitous members in oil reservoirs. Further analysis of primers used in those studies suggested that most primer pairs had fairly broad but low matches across the bacterial and archaeal domains, while a minority had selective matches to certain taxa or low matches to all the microbial taxa tested. Thus, it indicated that primers may play an important role in determining which taxa would be detected.
Matched MeSH terms: Oil and Gas Fields/microbiology*
Decommissioning of the offshore platform as an artificial reef, known as Rigs-to-Reefs (R2R), has become a sustainable approach for oil companies. The platform was reused to serve the underwater ecosystem as an artificial reef for a new marine ecosystem which helps to tackle food security issue. This paper presents the findings of the formulation of the reefing viability index to recognize an offshore region that can be used for R2R projects within the South China Sea. The combined effects of spatial data, numerical modelling, and geographic system (GIS) are proposed to study the relationship of spawning ground coral reefs, diversity, and planula larvae in the process of colonization to establish a map of the reef potential environment. Coral connectivity and spawning behaviour were studied to determine the possible source of coral seedling released during the spawning season, twice a year. A geographic reef viability index was established consisting of seven parameters which are coral larval density, pelagic larval length, sea currents, temperature, chlorophyll-a, depth, and substrate availability. The ocean hydrodynamic model was designed to resemble the pattern of larval scattering. By using the simulations and rankings, there were 95 (21%) sites which could probably be used for in situ reefing, whereas 358 (79%) sites were likely ideal for ex situ reefing. Validation of the viability index was carried out using media footage assessment of remotely operated vehicle (ROV).
Microbial communities of two oil reservoirs from Malaysia, denoted as Platform Bo and Platform Pe were studied using
culture-independent approach. Environmental DNA was extracted and the universal amplified ribosomal region (UARR)
was target amplified for both prokaryotes and eukaryotes. The amplified products were purified and cloned into pTZ57R/T
vector to construct the 16S/18S rDNA library. Restriction endocucleases HhaI and MspI were used to screen the library.
From that, 125 and 253 recombinant plasmid representative clones from Platform Bo and Platform Pe, respectively, were
sent for DNA sequencing. Twenty-six operational taxonomic units (OTUs) consist of 20 genera detected at Platform Bo
and 17 OTUs consist of 13 genera detected at Platform Pe. Marinobacter and Acinetobacter species co-occurred in both
platforms whereas the rest are site-specific. Gammaproteobacteria accounted for 86.0% of the microbial community in
Platform Bo, where OTUs affiliated to Marinobacter, Pseudomonas and Marinobacterium that were the most abundant. The
major OTUs in the Platform Pe were with affinities to Achromobacter, followed by Stenotrophomonas and Serratia. The
only archaeal isolates were detected in Platform Pe, which affiliated to Thermocladium. The singletons and doubletons
accounted for about 50.0% of the OTU abundance in both platforms, which considerably significant despite their rare
occurrence.
Despite the significance of biogenic methane generation in coal beds, there has never been a systematic long-term evaluation of the ecological response to biostimulation for enhanced methanogenesis in situ. Biostimulation tests in a gas-free coal seam were analysed over 1.5 years encompassing methane production, cell abundance, planktonic and surface associated community composition and chemical parameters of the coal formation water. Evidence is presented that sulfate reducing bacteria are energy limited whilst methanogenic archaea are nutrient limited. Methane production was highest in a nutrient amended well after an oxic preincubation phase to enhance coal biofragmentation (calcium peroxide amendment). Compound-specific isotope analyses indicated the predominance of acetoclastic methanogenesis. Acetoclastic methanogenic archaea of the Methanosaeta and Methanosarcina genera increased with methane concentration. Acetate was the main precursor for methanogenesis, however more acetate was consumed than methane produced in an acetate amended well. DNA stable isotope probing showed incorporation of 13C-labelled acetate into methanogenic archaea, Geobacter species and sulfate reducing bacteria. Community characterisation of coal surfaces confirmed that methanogenic archaea make up a substantial proportion of coal associated biofilm communities. Ultimately, methane production from a gas-free subbituminous coal seam was stimulated despite high concentrations of sulfate and sulfate-reducing bacteria in the coal formation water. These findings provide a new conceptual framework for understanding the coal reservoir biosphere.