METHODS: This is a true experimental post-test-only group design study, using male Wistar rats (Ratus novergicus) with weight-drop-induced traumatic brain injury. The subjects in this study were divided into four groups: two Control groups (Groups A and B) and two Therapy groups (Groups C and D). Groups C and D differed in the dose of Kencur ethanolic extract administered (600 mg/kgBW/day and 1,200 mg/kgBW/day, respectively). The Therapy groups were then subdivided into those receiving therapy for 24 h (C-24 and D-24) and those receiving therapy for 48 h (C-48 and D-48). Caspase-3 expression in brain tissue was evaluated at the end of the therapy using immunohistochemistry. All groups were subjected to a Kruskal-Wallis comparison test and the investigation continued with a Mann-Whitney U test to compare the two groups.
RESULTS: In traumatic brain injury rat models treated with Kaempferia galanga L. ethanolic extract at doses of 1,200 mg/kgBW/day within 48 h of therapy (D-48) compared to those who were not treated, there was a significant change in the cerebral expression of caspase-3 (P = 0.016). There was also a significant difference between the two doses of intervention (C-24 at 600 mg/kgBW/day and D-48 at 1,200 mg/kgBW/day; P = 0.016).
CONCLUSION: With a minimum of 48 h of treatment split into two doses, Kencur (Kaempferia galanga L.) ethanolic extract can decrease caspase-3 expression in rats with traumatic brain injury.
METHODS: A cross-sectional research study was carried out on 207 asthma adult patients belonging to different areas and ethnic groups from the country. The study setting was the PIMS hospital, which attracts patients from all over the country due to its facilities and cost-effective treatments. The body mass index (BMI) of asthma patients was calculated using the heights and weights of the study subjects. However, the pulmonary functions were calculated using a computerized spirometer i-e Spirolab III S/N 303681 in line with Winspiro PRO 7.1.version software. It presents the patient's forced vital capacity that expires in the first second of expiration to full (FEV1) in comparison to forced vital capacity (FVC) ratio, that is, Tiffeneau-Pinelli index was also recorded to determine the asthma severity.
RESULTS: According to recent surveys, the overall prevalence of patients with overweight and obesity was 29.0% and 23.7%, respectively. A Chi-square test was used, and a statistically significant relationship was observed between BMI and asthma severity (P < 0.001). The adult obese female patients presented poor pulmonary functions. The average FEV1/FVC ratio presented significant variance among four different categories of BMI with P < 0.05. This difference was due to the normal BMI category as the Tiffeneau-Pinelli index, that is, FEV1/FVC in the normal BMI group was significantly lower as compared to that in underweight and obese patients.
CONCLUSION: The study subjects presented raised asthma severity in accordance with the raised BMI. Obese patients presented comparatively raised asthma exacerbations. Moreover, a statistically significant association of gender difference was observed between obesity and asthma severity. It was concluded that adult asthmatic women with obesity presented raised asthma severity as compared to adult asthmatic males.
METHODS: Two parental E. guineensis individuals and 23 of their F1 progenies were collected and sequenced using the next-generation sequencing (NGS) technique on the Illumina platform. Chloroplast genomes were assembled de novo from the cleaned raw reads and aligned to check for variations. The sequences were compared and analyzed with programming language scripting and relevant bioinformatic softwares. Simple sequence repeat (SSR) loci were determined from the chloroplast genome.
RESULTS: The chloroplast genome assembly resulted in 156,983 bp, 156,988 bp, 156,982 bp, and 156,984 bp. The gene content and arrangements were consistent with the reference genome published in the GenBank database. Seventy-eight SSRs were detected in the chloroplast genome, with most located in the intergenic spacer region.The chloroplast genomes of 17 F1 progenies were exact copies of the maternal parent, while six individuals showed a single variation in the sequence. Despite the significant variation displayed by the male parent, all the nucleotide variations were synonymous. This study show highly conserve gene content and sequence in Elaeis guineensis chloroplast genomes. Maternal inheritance of chloroplast genome among F1 progenies are robust with a low possibility of mutations over generations. The findings in this study can enlighten inheritance pattern of Elaeis guineensis chloroplast genome especially among crops' scientists who consider using chloroplast genome for agronomic trait modifications.
METHODS: This prospective observational study included patients requiring CRRT in a tertiary intensive care unit (ICU) from February 2022 to January 2023. They were classified to either the RCA or usual care groups based on the anticoagulation technique chosen by the treating physician, considering contraindications. The CRRT prescription follows the institutional protocol. All relevant data were obtained from the ICU CRRT-RCA charts and electronic medical records. A cost analysis was performed.
RESULTS: A total of 54 patients (27 per group) were included, with no demographic differences. Sequential Organ Failure Assessment score and lactate levels were significantly higher in the usual care group. The number of filters used were comparable (p = .108). The median filter duration in the RCA group was numerically longer (35.00 [15.50-56.00] vs. 23.00 [17.00-29.00] h), but not statistically significant (p = .253). The duration of mechanical ventilation, vasopressor requirement, and mortality were similar, but the RCA group had a significantly longer ICU stay. The rate of adverse events was similar, with four severe metabolic alkalosis cases in the RCA group. The RCA group had higher total cost per patient per day (USD 611 vs. 408; p = .013).
CONCLUSION: In this resource-limited setting, RCA for CRRT appeared safe and had clinically longer filter lifespan compared with usual care, albeit the increased cost.
EXPERIMENTAL APPROACH: The extracts obtained with heat-assisted and cold water extraction of six species of fungi were analysed to determine their protein, carbohydrate and phenolic contents. Their cytotoxicity was tested against lung (A549) and breast (MCF-7 and MDA-MB-231) cancer cell lines. The most potent extract was further separated into its protein and non-protein fractions to determine their respective cytotoxicity.
RESULTS AND CONCLUSIONS: The cytotoxicity of the different extracts obtained with heat-assisted and cold water extraction varied. Comparing the two extractions, the cold water extraction resulted in a significantly higher yield of proteins (except M. purpureus) and phenolic compounds (except A. camphorata), while the extracts of I. obliquus and M. purpureus obtained with heat-assisted extraction had a significantly higher carbohydrate mass fraction. Notably, the cold water extract of I. obliquus showed cytotoxicity (IC50=(701±35) µg/mL), which was one of the highest of the extracts tested against A549 cells. The cold water extract of I. obliquus was selected for further studies. Our results showed that cold water extracts generally have higher cytotoxicity against selected human cancer cell lines, with the exception of O. sinensis and A. camphorata extracts.
NOVELTY AND SCIENTIFIC CONTRIBUTION: This study reports the advantage of cold water extracts of fungi over those obtained with heat-assisted extraction in terms of cytotoxicity against human cancer cell lines and emphasises the role of extraction conditions, particularly heat, in influencing chemical composition and cytotoxic effects.
METHODS: In our study we used structural-based drug designing, molecular simulation, and binding free energy approaches to identify the potent phytocompounds from various natural product databases (>100,000 compounds) able to inhibit the binding of NS1 with the TRIM25.
RESULTS: The molecular screening identified EA-8411902 and EA-19951545 from East African Natural Products Database, NA-390261 and NA-71 from North African Natural Products Database, SA-65230 and SA- 4477104 from South African Natural Compounds Database, NEA- 361 and NEA- 4524784 from North-East African Natural Products Database, TCM-4444713 and TCM-6056 from Traditional Chinese Medicines Database as top hits. The molecular docking and binding free energies results revealed that these compounds have high affinity with the specific active site residues (Leu95, Ser99, and Tyr89) involved in the interaction with TRIM25. Additionally, analysis of structural dynamics, binding free energy, and dissociation constants demonstrates a notably stronger binding affinity of these compounds with the NS1 protein. Moreover, all selected compounds exhibit exceptional ADMET properties, including high water solubility, gastrointestinal absorption, and an absence of hepatotoxicity, while adhering to Lipinski's rule.
CONCLUSION: Our molecular simulation findings highlight that the identified compounds demonstrate high affinity for specific active site residues involved in the NS1-TRIM25 interaction, exhibit exceptional ADMET properties, and adhere to drug-likeness criteria, thus presenting promising candidates for further development as antiviral agents against influenza A virus infections.
PURPOSE: The purpose of this in vitro study was to incorporate microparticles into a commercially available 3D printed denture base resin and compare its mechanical and biological properties with the conventional polymethyl methacrylate (PMMA) denture base material.
MATERIAL AND METHODS: Microparticles were collected from milled zirconia blanks and were blended with a 3D printing denture base resin (NextDent Denture 3D+). The optimal zirconia microparticle content (2%) for blending and printed was determined by using a liquid-crystal display (LCD) 3D printer. The printed specimens were then postrinsed and postpolymerized based on the manufacturer's instructions. Mechanical and biological characterization were carried out in terms of flexural strength, fracture toughness, and fungal adhesion. One-way ANOVA was carried out to analyze the results statistically.
RESULTS: The incorporation of microparticles in the 3D printed denture demonstrated higher mechanical strength (104.77 ±7.60 MPa) compared with conventional heat-polymerized denture base resin (75.15 ±24.41 MPa) (P