The evolution of microemulsion microstructure formed from didodecyl dimethyl ammonium bromide, water and cyclohexane which started from being structureless (fiat scattering profile) to a mean-field Ginsburg-Landau behaviour is shown. The evolution gave the characteristic Lorentzian scattering profile as the system approaches phase separation.
Evolusi mikrostruktur mikroemulsi yang terbentuk daripada didodesil dimetil ammonium bromida, air dan sildoheksana tiada berstruktur (profil serakan yang malar) kepada medan-min Ginsburg-Landau. Evolusi tersebut memberikan serakan Lorentz apabila komposisinya menghampiri sempadan pemisahan fasa.
The distribution patterns of flavonoids and cyclohexenyl chalcone derivatives in conventional propagated (CP) and in vitro-derived (CPA) field-grown plants of an important medicinal ginger, Boesenbergia rotunda, are described. A total of eight compounds were extracted from six organs (rootlet, rhizome, shoot base, maroon stem, stalk, and leaf) of the CP and CPA plants. Five major chromatographic peaks, namely, alpinetin, pinocembrin, pinostrobin, 4-hydroxypanduratin A, and panduratin A, were consistently observed by high performance liquid chromatography. Nonaerial organs had higher levels of flavonoids than the aerial ones for all types of samples. Among the compounds detected, pinostrobin and 4-hydroxypanduratin A were the most abundant flavonoid and cyclohexenyl chalcone derivative, respectively. The distribution and abundance of the bioactive compounds suggested that the shoot base could be more potentially useful for medicinal application than other organs of the plant and may be the site of storage or occurrence of biosynthetic enzymatic activities.
Boesenbergia rotunda (L.) cyclohexenyl chalcone derivatives, 4-hydroxypanduratin A and panduratin A, showed good competitive inhibitory activities towards dengue 2 virus NS3 protease with the Ki values of 21 and 25 microM, respectively, whilst those of pinostrobin and cardamonin were observed to be non-competitive. NMR and GCMS spectroscopic data formed the basis of assignment of structures of the six compounds isolated.
In this work, independent radial diffusion at arrayed nanointerfaces between two immiscible electrolyte solutions (nanoITIES) was achieved. The arrays were formed at nanopores fabricated by focused ion beam milling of silicon nitride (SiN) membranes, enabling the reproducible and systematic design of five arrays with different ratios of pore center-to-center distance (rc) to pore radius (ra). Voltammetry across water-1,6-dichlorohexane nanoITIES formed at these arrays was examined by the interfacial transfer of tetrapropylammonium ions. The diffusion-limited ion-transfer current increased with the ratio rc/ra, reaching a plateau for rc/ra ≥ 56, which was equivalent to the theoretical current for radial diffusion to an array of independent nanoITIES. As a result, mass transport to the nanoITIES arrays was greatly enhanced due to the decreased overlap of diffusion zones at adjacent nanoITIES, allowing each interface in the array to behave independently. When the rc/ra ratio increased from 13 to 56, the analytical performance parameters of sensitivity and limit of detection were improved from 0.50 (±0.02) A M(-1) to 0.76 (±0.02) A M(-1) and from 0.101 (±0.003) μM to 0.072 (±0.002) μM, respectively. These results provide an experimental basis for the design of arrayed nanointerfaces for electrochemical sensing.
The non-selective property of conventional polyurethane (PU) foam tends to lower its oil absorption efficiency. To address this issue, we modified the surface properties of PU foam using a rapid solvent-free surface functionalization approach based on the chemical vapor deposition (CVD) method to establish an extremely thin yet uniform coating layer to improve foam performance. The PU foam was respectively functionalized using different monomers, i.e., perfluorodecyl acrylate (PFDA), 2,2,3,4,4,4-hexafluorobutyl acrylate (HFBA), and hexamethyldisiloxane (HMDSO), and the effect of deposition times (1, 5 and 10 min) on the properties of foam was investigated. The results showed that all the modified foams demonstrated a much higher water contact angle (i.e., greater hydrophobicity) and greater absorption capacities compared to the control PU foam. This is due to the presence of specific functional groups, e.g., fluorine (F) and silane (Si) in the modified PU foams. Of all, the PU/PHFBAi foam exhibited the highest absorption capacities, recording 66.68, 58.15, 53.70, and 58.38 g/g for chloroform, acetone, cyclohexane, and edible oil, respectively. These values were 39.19-119.31% higher than that of control foam. The promising performance of the PU/PHFBAi foam is due to the improved surface hydrophobicity attributed to the original perfluoroalkyl moieties of the HFBA monomer. The PU/PHFBAi foam also demonstrated a much more stable absorption performance compared to the control foam when both samples were reused for up to 10 cycles. This clearly indicates the positive impact of the proposed functionalization method in improving PU properties for oil absorption processes.
This research explores the possibility of using fluorescence technique to detect the presence of volatile organic compounds based on a single sensing material. The material used was TiO2 nanoparticles coated with porphyrin dye. The TiO2 nanoparticles colloid is in a sol-gel form synthesized from titanium (IV) ethoxide in ethanol with addition of kalium chloride (KCl) as stabilizer. TiO2 nanoparticles were then coated with porphyrin dye, Manganase (III) 5,10,15,20 tetra (4-pyridyl)-21H, 23H porphine chloride tetrakis (metachloride). The coated nanoparticles were deposited on quartz substrate using self-assembly through dip coating technique. The sensing properties of the thin film toward volatile organic compounds; ethanol, acetone, cyclohexane and 2-propanol were studied using luminescence spectrometer. It was found that the thin film produced different emission spectra peaks for different volatile organic compounds (VOCs). Hence, it eases chemical identification process and potentially be use as fluorescence gas sensor.
Titanium dioxide (TiO2), porphyrin and TiO2 coated with dye porphyrin thin films were prepared on Quartz Crystal Microbalance (QCM) using sol-gel dip coating method and were tested for sensing of volatile organic compounds (VOCs). The porphyrin used was 5,10,15,20-tetraphenyl-21H,23H-porphine manganese (III) chloride (MnTPPCl). The sensing sensitivity was based on the change in the fundamental frequency of the QCM upon exposure towards six vapor samples, namely ethanol, acetone, cyclohexane, toluene, o-xylene and 2-propanol. It was found that all the thin films were sensitive towards all the vapors. However, the TiO2 coated MnTPPCl thin film exhibit the most sensitive and has good selectivity property.
Disseminated microsporidiosis is a life-threatening disease resulting from the haematogenous spread of microsporidia species. The diagnosis is challenging owing to its subtle nonspecific clinical presentation, which usually reflects the underlying organ involved. Therefore, a high index of suspicion is required for early diagnosis. Besides, tools for confirmatory laboratory diagnosis are limited. Currently, there is no direct diagnostic method that can detect the infection without involving invasive procedures. Clinical confirmation of disseminated microsporidiosis is usually based on light and transmission electron microscopy of infected tissue specimens. These are then followed by species detection using polymerase chain reaction (PCR). Disseminated microsporidiosis shows the potential to be cleared up by albendazole or fumagillin if they are detected and treated early. Based on a series of case reports, this review aims to present a current update on disseminated microsporidiosis with emphasis on the clinical manifestations based on the organ system infected, diagnostic approach and treatment of this devastating condition.
Limonene oxidation products (LOPs) have gained interest on their harmful health effects over time. Recently, studies have shown that the selected LOPs: 4-oxopentanal (4-OPA), 3-isopropenyl-6-oxo-heptanal (IPOH) and 4-acetyl-1-methylcyclohexene (4-AMCH) have sensory irritation effects in mice and inflammatory effects in human lung cells. This study was therefore undertaken to investigate the potential capacity of 4-OPA, IPOH and 4-AMCH to cause cell membrane damage, oxidative stress and inflammation in human bronchial (16HBE14o-) and alveolar (A549) epithelial cell lines. Overall results suggest that 4-OPA, IPOH have cytotoxic effects on human lung cells that might be mediated by ROS: the highest concentration applied of IPOH [500 μM] enhanced ROS generation by 100-fold ± 7.7 (A549) and 230-fold ± 19.9 (16HBE14o-) compared to the baseline. 4-OPA [500 μM] increased ROS levels by 1.4-fold ± 0.3 (A549) and by 127-fold ± 10.5 (16HBE14o-), while treatment with 4-AMCH [500 μM] led to 0.9-fold ± 0.2 (A549) and 49-fold ± 12.8 (16HBE14o-) increase. IPOH [500 μM] caused a decrease in the thiol-state balance (e.g. after 2 h, GSH:GSSG was reduced by 37% compared to the untreated 16HBE14o-cells). 4-OPA [500 μM] decreased the GSH:GSSG by 1.3-fold change in A549 cells and 1.4-fold change in 16HBE14o-cells. No statistically significant decrease in the GSH:GSSG in A549 and 16HBE14o-cell lines was observed for 4-AMCH [500 μM]. In addition, IPOH and 4-OPA [31.2 μM] increased the amount of the inflammatory markers: RANTES, VEGF and EGF. On the other hand, 4-AMCH [31.2 μM] did not show inflammatory effects in A549 or 16HBE14o-cells. The 4-OPA, IPOH and 4-AMCH treatment concentration and time-dependently induce oxidative stress and/or alteration of inflammatory markers on human bronchial and alveolar cell lines.
The behaviour of protonated ractopamine (RacH(+)) at an array of micro-interfaces between two immiscible electrolyte solutions (micro-ITIES) was investigated via cyclic voltammetry (CV) and linear sweep stripping voltammetry (LSSV). The micro-ITIES array was formed at silicon membranes containing 30 pores of radius 11.09±0.12 µm and pore centre-to-centre separation of 18.4±2.1 times the pore radius. CV shows that RacH(+) transferred across the water |1,6-dichlorohexane µITIES array at a very positive applied potential, close to the upper limit of the potential window. Nevertheless, CV was used in the estimation of some of the drug's thermodynamic parameters, such as the formal transfer potential and the Gibbs transfer energy. LSSV was implemented by pre-concentration of the drug, into the organic phase, followed by voltammetric detection, based on the back-transfer of RacH(+) from the organic to aqueous phase. Under optimised pre-concentration and detection conditions, a limit of detection of 0.1 µM was achieved. In addition, the impact of substances such as sugar, ascorbic acid, metal ions, amino acid and urea on RacH(+) detection was assessed. The detection of RacH(+) in artificial serum indicated that the presence of serum protein interferes in the detection signal, so that sample deproteinisation is required for feasible bioanalytical applications.
White feces syndrome (WFS) is an emerging problem for penaeid shrimp farming industries in SE Asia countries, Thailand, Malaysia, Vietnam, Indonesia, China, and in India. This occurrence of this syndrome is usually first evidenced by the appearance of white fecal strings floating on surface of the shrimp ponds. The gross signs of affected shrimp include the appearance of a whitish hindgut and loose carapace, and it is associated with reduced feeding and growth retardation. To investigate the nature of the white feces syndrome, samples of white feces and shrimp hepatopancreas tissue were collected from Penaeus vannamei in affected farms in Indonesia, and these were examined histologically. Within the white feces, we found densely packed spores of the microsporidian Enterocytozoon hepatopenaei (abbreviated as EHP) and relatively fewer numbers of rod-shaped bacteria. From WFS ponds, hepatopancreas samples form 30 individual shrimp were analyzed by histology and in situ hybridization. The results showed that all of the shrimp examined were infected with EHP accompanied by septic hepatopancreatic necrosis (SHPN). Midgut epithelial cells were also infected and this increased the number of tissue types being affected by EHP. By PCR, EHP was detected in all the samples analyzed from WFS-affected ponds, but not in those sampled from healthy shrimp ponds. To determine the modes of transmission for this parasite, we performed feeding and cohabitation bioassays, the results showed that EHP can be transmitted through per os feeding of EHP-infected hepatopancreas tissue to healthy shrimp and through cohabitation ofinfected and healthy shrimp. In addition, we found the use of Fumagillin-B, an antimicrobial agent, was ineffective in either reducing or eliminating EHP in infected shrimp.