We present a simulation study on negative bias temperature instability (NBTI) induced hole trapping in E' center defects, which leads to depassivation of interface trap precursor in different geometrical structures of high-k PMOSFET gate stacks using the two-stage NBTI model. The resulting degradation is characterized based on the time evolution of the interface and hole trap densities, as well as the resulting threshold voltage shift. By varying the physical thicknesses of the interface silicon dioxide (SiO2) and hafnium oxide (HfO2) layers, we investigate how the variation in thickness affects hole trapping/detrapping at different stress temperatures. The results suggest that the degradations are highly dependent on the physical gate stack parameters for a given stress voltage and temperature. The degradation is more pronounced by 5% when the thicknesses of HfO2 are increased but is reduced by 11% when the SiO2 interface layer thickness is increased during lower stress voltage. However, at higher stress voltage, greater degradation is observed for a thicker SiO2 interface layer. In addition, the existence of different stress temperatures at which the degradation behavior differs implies that the hole trapping/detrapping event is thermally activated.
A method for improving the thermoluminescence (TL) yield of silica-based optical fibres is demonstrated. Using silica obtained from a single manufacturer, three forms of pure (undoped) fibre (capillary-, flat-, and photonic crystal fibre (PCF)) and two forms of Ge-doped fibre (capillary- and flat-fibre) were fabricated. The pure fibre samples were exposed to 6 and 21MeV electrons, the doped fibres to 6MV photons. The consistent observation of large TL yield enhancement is strongly suggestive of surface-strain defects generation. For 6MeV irradiations of flat-fibre and PCF, respective TL yields per unit mass of about 12.0 and 17.5 times that of the undoped capillary-fibre have been observed. Similarly, by making a Ge-doped capillary-fibre into flat-fibre, the TL response is found to increase by some 6.0 times. Thus, in addition to TL from the presence of a dopant, the increase in fused surface areas of flat-fibres and PCF is seen to be a further important source of TL. The glow-curves of the undoped fibres have been analysed by computational deconvolution. Trap centre energies have been estimated and compared for the various fibre samples. Two trap centre types observed in capillary-fibre are also observed in flat-fibre and PCF. An additional trap centre in flat-fibre and one further trap centre in PCF are observed when compared to capillary fibre. These elevated-energy trap centres are linked with strain-generated defects in the collapsed regions of the flat fibre and PCF.
Pembangunan yang semakin pesat di Malaysia telah meningkatkan bilangan aktiviti antropogenik, sekaligus menyebabkan kemerosotan alam sekitar. Ini menunjukkan bahawa perlunya inventori hidupan liar dan sumber alam sekitar dijalankan di dalam kawasan hutan yang sedia ada, untuk mempromosikan peningkatan yang seimbang dalam pelan pemuliharaan dan pengurusan yang sedia ada, terutamanya untuk haiwan yang terancam seperti spesies mamalia kecil. Kajian mamalia kecil telah dijalankan di Tasik Bera, Hutan Simpan Ulu Gombak, Pusat Konservasi Hidupan Liar Sungkai, Pulau Pinang, dan Taman Negeri Wang Kelian. Harp trap, mist net, cage trap dan pitfall trap telah dipasang untuk kajian. Spesies Rhinolophus affinis (N = 61) merupakan spesies yang paling banyak ditangkap, diikuti dengan R. Lepidus (N = 27). Manakala untuk mamalia kecil tidak terbang, species Leopoldamys sabanus merupakan spesies paling banyak (N = 33) diikuti dengan Maxomys rajah (N = 25) dan Tupaia glis (N = 22). Dua spesies cencurut, Suncus etruscus dan Crocidura monticola masing-masing telah ditangkap dengan jumlah satu individu bagi setiap satu spesies. Hutan Simpan Ulu Gombak merekodkan kepelbagaian spesies yang paling tinggi (H’ = 2.754), manakala Pulau Pinang merekodkan nilai yang paling rendah (H’ = 2.245). Senarai mamalia kecil yang telah direkodkan melalui kajian ini merupakan maklumat yang signifikan bagi tujuan pemantauan dan konservasi biodiversiti.
The most sensitive part of a metal-oxide-semiconductor (MOS) structure to ionizing radiation is the
oxide insulating layer. When ionizing radiation passes through the oxide, the energy deposited creates
electron/hole pairs. Oxide trapped charge causes a negative shift in capacitance-voltage (C-V)
characteristics. These changes are the results of, firstly, incre using trapped positive charge in the
oxide, which causes a parallel shift of the curve to more negative voltages, and secondly, increasing
interface trap density, which causes the curve to stretch-out.
Lithium potassium borate (LKB) glasses co-doped with TiO2 and MgO were prepared using the melt quenching technique. The glasses were cut into transparent chips and exposed to gamma rays of (60)Co to study their thermoluminescence (TL) properties. The TL glow curve of the Ti-doped material featured a single prominent peak at 230 °C. Additional incorporation of MgO as a co-activator enhanced the TL intensity threefold. LKB:Ti,Mg is a low-Z material (Z(eff)=8.89) with slow signal fading. Its radiation sensitivity is 12 times lower that the sensitivity of TLD-100. The dose response is linear at doses up to 10(3) Gy. The trap parameters, such as the kinetics order, activation energy, and frequency factor, which are related to the glow peak, were determined using TolAnal software.
Pulp and paper mill sludge (PPMS) was found to be poorly colonised with thermophilic microorganisms. However,
evidence to support the need for inoculation to facilitate PPMS composting has only been demonstrated in one instance.
In this study, we aimed to: screen and identify PPMS digesting thermophilic bacterial strains; investigate effects of the
mixture of selected thermophilic bacterial strains on PPMS digestion; and utilize this mixture as start inoculum in PPMS
composting and assess the quality of compost product. The results showed that eleven thermophilic bacterial strains were
isolated from Bai Bang PPMS by the enrichment culture method. Among these, three strains which reflected high growth
rates on the plates of Minimal Media Agar supplemented with Bai Bang PPMS and showed hydrolytic and ligninolytic
activities on the agar plates containing appropriate inductive substrates were selected. Based on the morphological,
biochemical characteristics and 16S rRNA gene sequencing, they were identified as Bacillus subtilis. The inoculation
with the mixture of selected strains enhanced remarkably Bai Bang PPMS digestion. The dry weight decrease, volatile
suspended solids removal, dehydrogenase and protease activities in the inoculated sludge were 2.1-, 1.5-, 1.3- and 1.2-
fold higher, respectively, compared to the non-inoculated sludge. The assessment of compost quality based on stability
using the alkaline trap method and maturity using the germination and root elongation test showed that the inoculated
compost was stable and mature while the non-inoculated compost was unstable and immature. These thermophilic
bacterial strains therefore have great potential for Bai Bang PPMS composting.
A preliminary field study was undertaken to evaluate the efficacy of a mosquito trap; Mosquito Killing System (MKS) in
capturing mosquitoes and other insects. MKS has an automatic activation by the use of a photocell. It is also supplemented
with carbon dioxide and heat as attractants for mosquitoes and other insects. Three units of MKS were employed at three
different locations within two study sites for ten days. The mosquitoes and other insects that were trapped in MKS were
collected and morphologically identified daily in the laboratory. A total of 1,928 mosquitoes and other insects were
trapped in all units of MKS. High numbers of mosquitoes (93.05%), particularly Aedes sp. and Culex sp. were captured
from MKS. Among these, Culex quinquefasciatus (91.81%) was most abundant species collected. Only 0.84% of Aedes
aegypti and Aedes albopictus trapped in MKS. Female mosquitoes (83.44%) were found to be more attracted to MKS
compared to male mosquitoes of various species. These findings illustrated the potency of MKS utilization in surveillance
and control activities of Cx. quinquefasciatus; a nuisance mosquito and also potential vector of urban brancroftian
filariasis in Malaysia.
Metabarcoding, the coupling of DNA-based species identification and high-throughput sequencing, offers enormous promise for arthropod biodiversity studies but factors such as cost, speed and ease-of-use of bioinformatic pipelines, crucial for making the leapt from demonstration studies to a real-world application, have not yet been adequately addressed. Here, four published and one newly designed primer sets were tested across a diverse set of 80 arthropod species, representing 11 orders, to establish optimal protocols for Illumina-based metabarcoding of tropical Malaise trap samples. Two primer sets which showed the highest amplification success with individual specimen polymerase chain reaction (PCR, 98%) were used for bulk PCR and Illumina MiSeq sequencing. The sequencing outputs were subjected to both manual and simple metagenomics quality control and filtering pipelines. We obtained acceptable detection rates after bulk PCR and high-throughput sequencing (80-90% of input species) but analyses were complicated by putative heteroplasmic sequences and contamination. The manual pipeline produced similar or better outputs to the simple metagenomics pipeline (1.4 compared with 0.5 expected:unexpected Operational Taxonomic Units). Our study suggests that metabarcoding is slowly becoming as cheap, fast and easy as conventional DNA barcoding, and that Malaise trap metabarcoding may soon fulfill its potential, providing a thermometer for biodiversity.
Single-cell analysis has become the interest of a wide range of biological and biomedical engineering research. It could provide precise information on individual cells, leading to important knowledge regarding human diseases. To perform single-cell analysis, it is crucial to isolate the individual cells before further manipulation is carried out. Recently, microfluidic biochips have been widely used for cell trapping and single cell analysis, such as mechanical and electrical detection. This work focuses on developing a finite element simulation model of single-cell trapping system for any types of cells or particles based on the hydrodynamic flow resistance (Rh) manipulations in the main channel and trap channel to achieve successful trapping. Analysis is carried out using finite element ABAQUS-FEA™ software. A guideline to design and optimize single-cell trapping model is proposed and the example of a thorough optimization analysis is carried out using a yeast cell model. The results show the finite element model is able to trap a single cell inside the fluidic environment. Fluid's velocity profile and streamline plots for successful and unsuccessful single yeast cell trapping are presented according to the hydrodynamic concept. The single-cell trapping model can be a significant important guideline in designing a new chip for biomedical applications.
For reefs in South East Asia the synergistic effects of rapid land development, insufficient environmental policies and a lack of enforcement has led to poor water quality and compromised coral health from increased sediment and pollution. Those inshore turbid coral reefs, subject to significant sediment inputs, may also inherit some resilience to the effects of thermal stress and coral bleaching. We studied the inshore turbid reefs near Miri, in northwest Borneo through a comprehensive assessment of coral cover and health in addition to quantifying sediment-related parameters. Although Miri's Reefs had comparatively low coral species diversity, dominated by massive and encrusting forms of Diploastrea, Porites, Montipora, Favites, Dipsastrea and Pachyseris, they were characterized by a healthy cover ranging from 22 to 39%. We found a strong inshore to offshore gradient in hard coral cover, diversity and community composition as a direct result of spatial differences in sediment at distances <10 km. As well as distance to shore, we included other environmental variables like reef depth and sediment trap accumulation and particle size that explained 62.5% of variation in benthic composition among sites. Miri's reefs showed little evidence of coral disease and relatively low prevalence of compromised health signs including bleaching (6.7%), bioerosion (6.6%), pigmentation response (2.2%), scars (1.1%) and excessive mucus production (0.5%). Tagged colonies of Diploastrea and Pachyseris suffering partial bleaching in 2016 had fully (90-100%) recovered the following year. There were, however, seasonal differences in bioerosion rates, which increased five-fold after the 2017 wet season. Differences in measures of coral physiology, like that of symbiont density and chlorophyll a for Montipora, Pachyseris and Acropora, were not detected among sites. We conclude that Miri's reefs may be in a temporally stable state given minimal recently dead coral and a limited decline in coral cover over the last two decades. This study provides further evidence that turbid coral reefs exposed to seasonally elevated sediment loads can exhibit relatively high coral cover and be resilient to disease and elevated sea surface temperatures.